205 AND 211 TRACK-TYPE EXCAVATORS Technical Data For Wiring Diagram Caterpillar


Technical Data For Wiring Diagram
`

Fig. H801

(1) Headlights. right (low beam only)

(2) Headlights. left (low beam only)

(3) Alternator

(4) Regulator (integrated into alternator)

(5) Starter

(6) Batteries

(7) Temperature switch, hydraulic oil cooler

(8) Solenoid valve, hydraulic oil cooler

(9) Transmitter for diesel engine oil pressure fault light

(10) Transmitter for temperature gauge (Deutz: engine oil temp. - Perkins: coolant temp.)

(11) Transmitter for V-belt control to signal horn - Deutz engine only

(12) Transmitter for fuel indicator

(13) Solenoid valve for q/min - q/max

(14) Fault light (red) for engine oil pressure

(15) Fault light (red) for charging current

(16) Fault light (green) for hydraulic oil cooler

(17) Service hour meter

(18) Key toggle switch for q/min - q/max

(19)

(20)

(21) Key switch for preheating/starting, Deutz

(21a) Key switch for preheating/starting, Perkins

(22) Key toggle switch for low beam

(23) Key toggle switch for front working light

(24) Fuse box, 12-pole

(25) Fuse box, 8-pole

(26) Fuel indicator

(27) Remote temperature gauge (Deutz: engine oil temperature; Perkins: coolant temperature)

(28) Relay for V-belt control, Deutz engine

(28a) Relay for stopping engine, Perkins engine

(29) Socket for plugs, quadruple

(30) Pushbutton, signal horn

(31) Signal horn

(32) Front working light

(33) Windshield wiper motor

(34) Key toggle switch for windshield wiper

(35) Interior dome light

(36) Cigarette lighter (socket), if equipped

(37) Pushbutton for hydraulic optional function (in transmitter, right)

(38) Pushbutton for hydraulic optional function (in transmitter, left)

(39) Solenoid valve for stopping engine, Perkins engine only

(40) Ballast resistor for stopping engine, Perkins engine only

(41)

(42)

(43)

(44)

(45)

(46)

(47)

(48)

(49)

(50)

(51) Branch box for connector plug

(52) Rear working light

(53) Solenoid valve for hammer operation

(54) Solenoid valve for stroke frequency adjustment

(55) Engine compartment light

(56) Ballast resistor preheating (Duetz)

(56a) Ballast resistor preheating (Perkins)

(57) Preheating glow plug (Deutz)

(57a) Preheating glow plug (Perkins)

(58) Solenoid valve (Deutz)

(59) 3-Step switch for heater motor

(60) Motor for heating system

(61) Switch for refueling pump

(62) Refueling pump

(63) Fault light (red) for overload warning system (if equipped)

(64) Fault light (yellow) for preheating system (Deutz engine only)

(65) Compressor horn

(66) Relay for compressor horn

(67) Diode

(68) Pressure sensitive valve for overload warning device (if equipped)

(69) Electrical pump for windshield washer system

(70) Key toggle switch for compressor horn

(71) Key toggle switch for hammer operation

(72) Key toggle switch for stroke frequency adjustment

(73) Key toggle switch for rotating beacon

(74) Key toggle switch for working light

(75) Solenoid valve for hydraulic optional function

(76) Additional working light, (only for monoblock boom)

(77) Radio interference suppression filter (if equipped)

(78) Rotating beacon

(79) Buzzer, (overload warning system) if equipped

(80) Radio antenna, optional

(81) Radio (2.5 A fuse contained in radio set), optional

(82) Radio speaker, optional

(83) Radio headset, optional

(84) Cable connector with 2 A fuse, for radio, optional

(85) Electric pedal (in operator's compartment), for hammer operation

(86) Key toggle switch for windshield washer

ws = whitege = yellowrt = redgn = greengr = graybr = brownbl = bluesw = black

Information System:

205 AND 211 TRACK-TYPE EXCAVATORS Lubrication and Maintenance Chart
205 AND 211 TRACK-TYPE EXCAVATORS Coolant, Fuel and Lubricant Specifications
205 AND 211 TRACK-TYPE EXCAVATORS Upper Structure Technical Data
205 AND 211 TRACK-TYPE EXCAVATORS Safety
SUPPLEMENT FOR 206 & 212 WHEEL-TYPE EXCAVATORS Steering
SUPPLEMENT FOR 206 & 212 WHEEL-TYPE EXCAVATORS Final Drive
SUPPLEMENT FOR 206 & 212 WHEEL-TYPE EXCAVATORS Transmission and Transfer Gear
SUPPLEMENT FOR 206 & 212 WHEEL-TYPE EXCAVATORS Final Drive
SUPPLEMENT FOR 206 & 212 WHEEL-TYPE EXCAVATORS Differential
SUPPLEMENT FOR 206 & 212 WHEEL-TYPE EXCAVATORS Rear Axle with Transmission and Transfer Gear
214 & 224 WHEEL-TYPE EXCAVATORS Cab Heater
214 & 224 WHEEL-TYPE EXCAVATORS Fault Diagnosis
205 AND 211 TRACK-TYPE EXCAVATORS Hydraulic System
205 AND 211 TRACK-TYPE EXCAVATORS Instructions For Testing And Adjusting Hydraulic Pressure
205 AND 211 TRACK-TYPE EXCAVATORS Pilot-Operated Main Relief Valve
205 AND 211 TRACK-TYPE EXCAVATORS Variable Double Pump
205 AND 211 TRACK-TYPE EXCAVATORS Pump Delivery Diagrams
205 AND 211 TRACK-TYPE EXCAVATORS Hydraulic Hammer (With Stroke Frequency Adjustment)
205 AND 211 TRACK-TYPE EXCAVATORS Check and Relief Valve (For Boom Cylinder Protection)
205 AND 211 TRACK-TYPE EXCAVATORS Basic Cooling Block (Diverter Valve)
205 AND 211 TRACK-TYPE EXCAVATORS Control Valve Bank, Optional Actuators
205 AND 211 TRACK-TYPE EXCAVATORS Towing
205 AND 211 TRACK-TYPE EXCAVATORS Flexible Coupling
205 AND 211 TRACK-TYPE EXCAVATORS Boom Lowering Speed Control Valve