816K Landfill Compactor Transmission Magnetic Screen - Clean Caterpillar


Transmission Magnetic Screen - Clean
`

------ WARNING! ------

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact the skin.




Illustration 1g06022110

  1. Park the machine on a level surface. Engage the parking brake and stop the engine.


    Illustration 2g01166968

  2. Remove screen cover plate (1).

  3. Remove wave washer (2), screen (3), and magnetic tube assembly (4).


    NOTICE

    Do not drop or rap the magnets against any hard objects. Replace any damaged magnets.


  4. Wash the screen and the magnetic tube assembly in clean, nonflammable solvent. Clean the magnets with a cloth, a stiff bristle brush or air pressure.

  5. Install the magnetic tube assembly, the screen, and the wave washer.

  6. Inspect seal (5). If the seal is damaged, replace the seal.

  7. Install the screen cover plate.

  8. Start the engine and operate the engine at low idle. Make sure that the parking brake is engaged. Check for leaks and make any necessary repairs.

  9. Check the oil level in the transmission oil tank. If necessary, add oil. For the proper procedure, refer to Operation and Maintenance Manual, "Transmission Tank Oil Level - Check".

Information System:

C9.3 Tier 4 Final Engines Cylinder Head Valves
415F2 Industrial Loader Machine Systems Refrigerant Accumulator - Remove and Install
415F2 Industrial Loader Machine Systems Cab - Install
415F2 Industrial Loader Machine Systems Cab - Remove
415F2 Industrial Loader Machine Systems Canopy - Remove and Install
415F2 Industrial Loader Machine Systems Window Wiper and Wiper Motor (Front) - Remove and Install
415F2 Industrial Loader Machine Systems Steering Wheel - Remove and Install
415F2 Industrial Loader Machine Systems Steering Metering Pump - Remove and Install
320D2 GC Excavator Engine Supplement Engine - Remove and Install
415F2 Industrial Loader Machine Systems Hydraulic Tank - Remove and Install
415F2 Industrial Loader Machine Systems Piston Pump (Main Hydraulic) - Remove and Install
307E2 Mini Hydraulic Excavator Machine Systems Final Drive and Travel Motor - Remove
GSV520 and GSV525 Orange Peel Grapples Head Assembly and Bushing - Remove and Install
An Improved Routing is Now Used for the Pilot Hose on Certain 336D2 and 340D2 Excavators {5057, 5059}
Improved Software is Available to Re-Flash the Monitor Software for Certain 307E2 Tier 4 Final Mini Hydraulic Excavators {7490, 7601, 7603, 7610, 7620}
An Improved Air Conditioning Compressor Is Used On Certain Wheeled Excavators {1152, 1802}
320D2 GC Excavator Engine Supplement Radiator and Hydraulic Oil Cooler - Remove and Install
320D2 GC Excavator Engine Supplement Radiator - Remove and Install
Replacement Procedure for the Return Hose Assemblies on Certain 308E2 Excavators {5057, 5068}
320D2 GC Excavator Engine Supplement Hydraulic Oil Cooler - Remove and Install
415F2 Industrial Loader Machine Systems Air Conditioner and Heater - Remove and Install
415F2 Industrial Loader Machine Systems Fuel Tank - Remove and Install
307E2 Mini Hydraulic Excavator Machine Systems Refueling Pump - Remove and Install
Installing the <NOBR>387-6451</NOBR> Ride Control Kit to a Machine That Has an ECM {5004}