349F and 352F Excavators Monitoring System - Monitor with Installed Cat Grade With Assist Caterpillar


Monitoring System - Monitor with Installed Cat Grade With Assist
`
2.1. Monitor With Installed Cat Grade With Assist With Tilt (If Equipped)

------ WARNING! ------

Once the system is placed in automatic mode, linkage and swing movement may occur.

Ensure that all personnel are clear of the machine before you place the system in automatic mode.

Personal injury could occur.


If Grade with Assist is installed and Software Enabled Attachment (SEA) is enabled, then a button is added to the Cat@ Grade Control screens. This button is used to select manual or auto.



Illustration 1g03874655
Multi-Information Area with Button to Select Auto Mode


Illustration 2g03874678
Multi-Information Area with Auto Mode Indicated

When in auto mode, all auto functions are enabled.

Note: In auto mode e-ceiling and e-floor are active, and the linkage is stopped when the limit height or depth has been reached.



Illustration 3g03874649
Multi-Information Area with Button to Select Manual Mode


Illustration 4g03874670
Multi-Information Area Manual Mode Indicated

When in manual mode no auto functions are enabled except for e-ceiling and e-floor.

Note: In manual mode e-ceiling and e-floor are active, and an alarm is indicated when the linkage limit height or depth has been reached.



Illustration 5g03874677
Auto Cancel Mode Indicated

When in auto cancel mode, auto is prohibited due to system condition.

Monitor With Installed Cat Grade With Assist With Tilt (If Equipped)

This is an additional available function to the Cat Grade With Assist. This function uses the tilt bucket and the tilt bucket angle sensor to allow for greater control of the bucket. The bucket focus selections and tilt are available for display on the monitor.



Illustration 6g06108945
Bucket icon states
(A) Center focus, left tilt
(B) Center focus, flat tilt
(C) Center focus, right tilt
(D) Right focus, left tilt
(E) Right focus, flat tilt
(F) Right focus, right tilt
(G) Left focus, left tilt
(H) Left focus, flat tilt
(J) Left focus, right tilt

Illustration 6 shows the various angle states of the direction of the bucket slope and the bucket focus states for the icon. The square on the bucket indicates the position of the bucket focus.

Note: The default bucket focus position is bucket center.



Illustration 7g06108996
Bucket focus state selection monitor

Information System:

314F and 315F Excavators Machine System Specifications Chassis Lighting
An Improved Main Control Valve is Now Used on 308E2 CR and 308E2 SR Mini Hydraulic Excavators {5051}
314F and 315F Excavators Machine System Specifications Control Valve (Auxiliary)
349F and 352F Excavators Joystick Controls - Cat Grade With Assist System
GSH420, GSH425, GSH440, GSH520, GSH525, GSH455 and GSH555 Orange Peel Grapples Head Assembly and Bushing - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems Window Wiper Motor - Remove and Install - Lower
336D 2L and 340D 2L Excavators Machine Systems Hydraulic Lockout Control - Remove and Install
352F Mobile Hydraulic Power Unit (MHPU) Machine System Main Hydraulic System
New Rear Axle and Brake Control Groups Are Now Used On Certain 424B Backhoe Loaders {3278, 3282, 4269}
Improved Hoses Are Now Used on Certain Backhoe Loaders {5057}
336D 2L and 340D 2L Excavators Machine Systems Fuel Tank - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems Cab - Remove and Install
307 Hydraulic Excavator Engine Supplement Refrigerant Compressor - Remove and Install
924K, 926M, 930K, 930M, 938K, and 938M Wheel Loaders Machine System Pilot Pressure - Check
Installation of the <NOBR>487-5000</NOBR> Auxiliary Hydraulic Lines Gp on Certain Hydraulic Excavators {5057}
DFS118, DFS121 and DFS124 Silage Defacers Safety Messages
GSH420, GSH425, GSH440, GSH520, GSH525, GSH455 and GSH555 Orange Peel Grapples Rotator Motor and Manifold - Remove and Install
GSH420, GSH425, GSH440, GSH520, GSH525, GSH455 and GSH555 Orange Peel Grapples Rotator Motor and Manifold - Disassemble
314F and 315F Excavators Machine System Specifications Pilot Lines (Main Pump)
314F and 315F Excavators Machine System Specifications Swing Motor
314F and 315F Excavators Machine System Specifications Heater and Air Conditioner Mounting
GSH420, GSH425, GSH440, GSH520, GSH525, GSH455 and GSH555 Orange Peel Grapples Hydraulic Rotator - Remove and Install
314F and 315F Excavators Machine System Specifications Pump Lines
314F and 315F Excavators Machine System Specifications Hydraulic Tank and Filter