5080 SUPPLEMENT FOR HYDRAULIC EXCAVATORS Working Ranges Caterpillar

¹The Ultra High Demolition Configuration includes the following parts: UHD Boom, UHD Fore-Boom, UHD Stick, 14000 kg Counterweight, European Cab, 750 mm track shoes and no tool.

Illustration 8

(1) Incorrect position;

(2) Correct position;

(3) Incorrect position;

(4) Correct position

The track frames must be in working position (track frames fully extended).

Ultra High Demolition Configuration (40 m)

Illustration 9

Table 7

¹The Ultra High Demolition Configuration includes the following parts: UHD Boom, UHD Fore-Boom, UHD Stick, 14000 kg Counterweight, European Cab, 750 mm track shoes and no tool.

Illustration 10

(1) Incorrect position;

(2) Correct position;

(3) Incorrect position;

(4) Correct position

The track frames must be in working position (track frames fully extended).

Ultra High Demolition Configuration with recommended tool and special mounting bracket

Verachtert Shear (S80)

Illustration 11

Table 8

¹The Ultra High Demolition configuration includes the following parts: UHD Boom, UHD Fore-Boom, 14000 kg Counterweight, European Cab, 750 mm track shoes and with Shear S80.

Illustration 12

(1) Incorrect position;

(2) Correct position;

(3) Incorrect position;

(4) Correct position

The track frames must be in working (track frames fully extended).

Retrofit Bent Boom Configuration

Illustration 13

Table 9³

¹These specification are for a machine with the following items: Retrofit configuration (Bent Position), 14000 kg counterweight, 3.4m demolition Stick, European Demolition Cab, Falling Object Guard, "J" Family Linkage and 3.0m Bucket.

NOTE: The working range is valid for 360 degrees.

Retrofit Straight Boom Configuration

Illustration 14

Table 10³

¹These specification are for a machine with the following items: Retrofit configuration (Straight Position), 14000 kg counterweight, 3.4m demolition Stick, European Demolition Cab, Falling Object Guard, "J" Family Linkage and 3.0m Bucket.

NOTE: The working range is valid for 360 degrees.

Lifting Capacities

SMCS Code: 7000

NOTE: The pictograph symbols in the next illustration appear in the lift charts throughout this supplement. The symbols are explained in the text that follows the illustration.

A = Load point height

B = Load radius over front

C = Load radius over side

D = Load at maximum reach

E = Limited by hydraulic rather than tipping load. The above loads are in compliance with hydraulic excavator lift capacity ratings standard ISO/DIN 10567, they do not exceed 87% of hydraulic lifting capacity or 75% of tipping capacity. The mass of all lifting accessories must be deducted from the above lifting capacities.

Retrofit Bent Boom Configuration

Table 11

Retrofit Straight Boom Configuration

Table 12

¹"ISO 10567" "SAE J1097"

²Capacity is limited by hydraulics rather than by a tipping load. The loads do not exceed 87 percent of hydraulic lifting capacity or 75 percent of tipping capacity. Weight of all lifting accessories must be substracted from the lifting capacities.