305 CR Mini Hydraulic Excavator Window Wiper and Washer Control - If Equipped Caterpillar


Window Wiper and Washer Control - If Equipped
`
305 CR Mini Hydraulic Excavator [SEBU7428]
ELECTRICAL AND STARTING SYSTEM
WIRING GP
305 CR Mini Hydraulic Excavator Window Wiper and Washer Control - If Equipped
305 CR Mini Hydraulic Excavator Fuses - Replace


NOTICE

If the wiper does not operate with the switch in the ON position, turn the switch off immediately. Check the cause. If the switch remains on, motor failure can result.




Illustration 1g00813703

Machines that are equipped with a cab have a window wiper as standard equipment. The switch that operates the wiper blade and the washer is located on the upper left side of the cab.


NOTICE

If the washer is used continuously for more than twenty seconds or used when no washer solution comes out, pump failure can result.


Window Wiper Switch and Window Washer Switch - Turn the switch clockwise in order to turn on the wiper. Turn the switch counterclockwise in order to turn off the wiper. Push in on the switch in order to spray washer fluid on the window. Release the switch in order to stop spraying washer fluid.

Information System:

M316C, M318C and M322C Excavators and M318C and M322C Material Handlers Plate Locations and Film Locations
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers Boom/Stick/Bucket Combinations
3500B Engines for 5130B and 5230B Excavators Electrical Power Supply
325C L and 325C LN Excavator Lifting Capacities Lifting Capacities - 325C Excavator
305 CR Mini Hydraulic Excavator Light Switches
M325B Material Handler Machine Systems Boom Cylinder - Assemble
W345B Series II Material Handler Hydraulic System Control Valve (Boom Lowering)
5230B Excavator Machine Systems Gear Pump (Pump Drive Lubrication) - Assemble
M325B Material Handler Machine Systems Boom Cylinder - Disassemble
M325B Material Handler Machine Systems Stick Cylinder - Assemble
M325B Material Handler Machine Systems Stick Cylinder - Disassemble
3500B Engines Electronic Circuits
5230B Excavator Machine Systems Pilot Valve (Travel) - Remove
C9.3 Engines for Caterpillar Built Machines Electrical System
5130B Excavator Pump Drive Oil - Change
3126B Engine for Caterpillar Built Machines Engine Fan Control Solenoid Circuit - Test
2001/09/17 Correction to Serial Numbers for "Alternator Debris Guard Available" {1405}
3126B Engines Fuel System - Inspect
5130B Excavator Automatic Lubrication System Grease - Add
3500B Engines for 5130B and 5230B Excavators Ether Injection System
305 CR Mini Hydraulic Excavator Window (Front) - If Equipped
5230B Excavator Hydraulic System Solenoid Valves (Pilot Manifold)
3500B Engines for 5130B and 5230B Excavators Ground Level Shutdown Switch
C15 Petroleum Generator Set Engines Electronic Unit Injector - Adjust