305 CR Mini Hydraulic Excavator Blade Control Caterpillar


Blade Control
`
1.1. Control for the Angle Blade (If Equipped)


Illustration 1g00817793

The blade control lever is located next to the right joystick.

Float - Push the lever forward to the detent position. The blade will lower to the ground. The blade will float with the contour of the ground. The lever will remain in the FLOAT position until the lever is removed from the detent position. After the lever is removed from the detent position, the lever will return to the HOLD position.

Lower - Push the lever forward in order to lower the blade. The lever will return to the HOLD position when you release the lever. The blade will remain in the selected position.

Hold - The lever will return to the HOLD position when the lever is released from the RAISED or LOWERED position.

Raise - Pull the lever backward in order to raise the blade. The lever will return to the HOLD position when you release the lever. The blade will remain in the selected position.

Control for the Angle Blade (If Equipped)



Illustration 2g01154380

The control button for the blade is located on the top of the blade control lever.

Left Angle (1) - Push down on the left button in order to angle the blade to the left.

Right Angle (2) - Push down on the right button in order to angle the blade to the right.

Information System:

5130B Excavator Hydraulic System Oil Filter (Pilot) - Replace
5130B Excavator Cooling System Coolant Extender (ELC) - Add
303 CR Mini Hydraulic Excavator Swing Boom Control
325C L and 325C LN Excavator Lifting Capacities Working Ranges
H45/H45 S, H50/H50 S, 63/H63/H63 S, 70/70 S/H70/H70 S, H90C/H90C S and 100/H100/H100 S Hydraulic Hammers Hydraulic Hammer
3064 and 3066 Engines for Caterpillar Built Machines Crankshaft
5230B Excavator Machine Systems Selector Valve (Hydraulic Activation) - Remove
325C Excavator Hydraulic System Gear Pump (Fan Motor) - Test
5230B Excavator Machine Systems Swivel - Assemble
325C Excavator Hydraulic System Travel Motor - Test - Measurement of Case Drain Oil
325C Excavator Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
5130B Excavator Cooling System Coolant (ELC) - Change
5130B Excavator Hydraulic System High Pressure Screen - Check/Replace
2001/08/13 Special Instruction, REHS1129, "Starting Motor Solenoid - Replace" Is Available {1467}
305 CR Mini Hydraulic Excavator Engine Starting
3046 Engine for Caterpillar Built Machines Fuel System - Prime - In-line Fuel Pump
325C Excavator Plate Locations and Film Locations
325C Excavator Hydraulic System Gear Pump (Pilot) - Test
2001/09/10 The Reverse Steering Indicator is Removed {1408, 1429}
3046 Engine for Caterpillar Built Machines Low Idle RPM - Adjust - In-line Fuel Pump
345B Series II Excavator Machine System Specifications Bucket Linkage - U-Family
3046 Engine for Caterpillar Built Machines High Idle RPM - Adjust - In-line Fuel Pump
M312, M315, M318 and M320 Excavators Hydraulic System Swing Motor
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Engine Starting with Jump Start Cables