Axle Oil (Rear) - Change
`
M313C and M315C Excavators
[SEBU7868]
POWER TRAIN
AXLE GP
M318 and M320 Excavators
Axle Oscillation Bearings - Lubricate
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers
Oscillating Axle Control
M313C and M315C Excavators
Axle Oil (Rear) - Change
Show/hide table
![]() | |
Illustration 1 | g00102672 |
(1) Filler plug |
Show/hide table
![]() | |
Illustration 2 | g00333762 |
(2) Drain plug |
Operate the machine for an adequate amount of time in order to warm the oil.
Filler plug (1) and drain plug (2) are located under the machine on the rear axle.
- Remove the dirt that is around filler plug (1) and around drain plug (2) .
Note: Refer to the Operation and Maintenance Manual, "General Hazard Information" for information in containing fluid spillage.
- Remove filler plug (1) .
- Remove drain plug (2). Drain the oil into a suitable container.
Note: Dispose of any used oil according to local regulations.
- Clean drain plug (2) .
- Inspect the O-ring seal. If damage or wear is noticed on the O-ring seal, replace the seal.
- Install drain plug (2) .
- Fill the axle with oil to the bottom of the filler plug opening. See Operation and Maintenance Manual, "Capacities (Refill)".
- Clean filler plug (1) .
- Inspect the O-ring seal. If damage or wear is noticed on the O-ring seal, replace the seal.
- Install filler plug (1) .
Information System:
Quick Coupler Wedge Lock(Wheel Loader)
Model View Illustrations
W345B Series II Material Handler Hydraulic System
Pilot Valve (Joystick)
2001/10/15
Correction to Disassembly and Assembly , "Swing Frame" and Disassembly and Assembly , "Swing Cylinder" {6506}
312C Excavator Machine Systems
Blade Cylinder - Install
M316C, M318C and M322C Excavators and M318C and M322C Material Handlers
Shipping the Machine
2001/12/24
The New Steering Control Valve Groups Improve Service Life {5051}
Quick Coupler Wedge Lock(Wheel Loader)
Quick Coupler Operation
Horizontal Pin Lock Series PW Quick Coupler
Operation
Quick Coupler Wedge Lock(Wheel Loader)
Model View Illustrations
312C Excavator Machine Systems
Blade Cylinder - Remove
5130B Excavator
Ladders
345B, 345B Series II and W345B Series II Excavators Engine and Pump Control
Senders
3046 Engine For Caterpillar Built Machines
Fuel Shutoff Solenoid - Remove and Install
325C Excavator Hydraulic System
Travel Counterbalance Valve
322C Excavator Hydraulic System
Swing Hydraulic System
325C Excavator Hydraulic System
Return Hydraulic System
37-MT, 41-MT, and 42-MT Series Starting Motors
Starting Motor Solenoid - Test
325D and 329D Excavators Hydraulic System
Check Valve (Return Makeup) - Slow Return Check Valve
325D and 329D Excavators Hydraulic System
Bypass Valve (Return) - Bypass Check Valve
312C Excavator Machine Systems
Blade - Remove and Install
3126B Engine for Caterpillar Built Machines
Throttle Lock Switch Circuit - Test
3046 Engine for Caterpillar Built Machines
Water Pump - Test
345B, 345B Series II and W345B Series II Excavators Engine and Pump Control
Solenoid Valves
345B, 345B Series II and W345B Series II Excavators Engine and Pump Control
Related Components