Hydraulic System Oil Level - Check
`
305 CR Mini Hydraulic Excavator
[SEBU7428]
305 CR Mini Hydraulic Excavator
Fuses - Replace
305 CR Mini Hydraulic Excavator
Hydraulic System Oil - Change
HYDRAULIC SYSTEM
TANK GP
305 CR Mini Hydraulic Excavator
Hydraulic System Oil Level - Check
305 CR Mini Hydraulic Excavator
Hydraulic System Oil - Change
Note: Check the hydraulic system oil level with the machine on a level surface.
- Extend the stick and the bucket fully. Lower the boom so that the bucket is rested on the ground. Lower the blade to the ground.
Show/hide table
Illustration 2 g00825530 - The sight gauge is located on the side of the hydraulic tank.
- Maintain the hydraulic system oil level between top mark (A) and bottom mark (B ) on the sight gauge.
- If additional hydraulic oil is needed, the hydraulic oil filler cap is located under the access door on the right side of the machine.
Show/hide table
Illustration 3 g00825535 Show/hide tableNOTICE Never remove the hydraulic tank filler cap from the hydraulic tank if the oil is hot. Hot oil can cause burns.
Air can enter the system. Air in the system can cause pump damage.
- Remove the hydraulic tank filler cap slowly in order to relieve any pressure. Add hydraulic oil, if necessary.
- Inspect the gasket on the hydraulic tank filler cap. If the gasket is damaged replace the hydraulic tank filler cap.
- Install the hydraulic tank filler cap.
Show/hide table
![]() | |
Illustration 1 | g00825529 |
Information System:
3524B Engines for Off-Highway Trucks
E272 Inlet Air Restriction Warning
315C Excavator Hydraulic System
Relief Valve (Main) - Test and Adjust
3512B Petroleum Engines with the ADEM 2 Electronic Control Module
E173 High Exhaust Temperature Warning
3046 Engine for Caterpillar Built Machines
Engine Valve Lash - Inspect/Adjust
2001/10/15
Correction to Systems Operation, Testing and Adjusting , "Pump Control (Negative Flow) - Test" {5070}
H45/H45 S, H50/H50 S, 63/H63/H63 S, 70/70 S/H70/H70 S, H90C/H90C S and 100/H100/H100 S Hydraulic Hammers
Mounting Bracket
3512B Petroleum Engines with the ADEM 2 Electronic Control Module
E099 Engine Oil Filter Restriction Warning
325C Excavator Machine System Specifications
Stick
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks
E095 Fuel Filter Restriction Warning
305 CR Mini Hydraulic Excavator
Fuses - Replace
312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2
Engine Controller Is Abnormal - Troubleshoot - 590
325C Excavator Machine System Specifications
Stick
325C LCR Excavator Machine System Specifications
Stick - R3.0C
5230B Excavator Machine Systems
Piston Motor (Air Conditioner) - Remove and Install
325C Excavator Machine System Specifications
Stick - R2.65C
312C and 312C L Excavator
Capacities (Refill)
312C and 312C L Excavator
Cooling System Hoses - Inspect
305 CR Mini Hydraulic Excavator
Hydraulic System Oil - Change
325C Excavator Machine System Specifications
Stick - R3.2C
C-9 Engine for the 330C Excavator and for the 330C Mobile Hydraulic Power Unit
Sensors and Electrical Connectors
2001/11/19
Prerequisites for Flashing Software into Machine Electronic Control Modules {7620}
CS56B, CP56B, CS66B, CS68B and CP68B Vibratory Soil Compactors Machine Systems
Vibratory Support - Disassemble
5230B Excavator Machine Systems
Control Valve (Rear) - Disassemble
312C and 312C L Excavator
Blade Control