315C Excavator Window (Front) Caterpillar


Window (Front)
`

Note: The sun visor (if equipped) must be down before the front window is raised. The front window will not lock in the overhead storage position with the sun visor in the raised position.

To provide full ventilation inside the cab, the upper window and the lower window can be fully opened.

------ WARNING! ------

When opening or closing the windows, be extra careful to prevent any personal injury. The hydraulic lockout control must be in the LOCKED position in order to prevent any possibility of sudden movement of the machine due to inadvertent contact with the hydraulic control(s).

----------------------

Do not change the position of the window until the following items have been done:

  • Park the machine on a level surface.

  • Lower the equipment to the ground.

  • Move the hydraulic lockout control to the LOCKED position.

  • Stop the engine.




Illustration 1g00680493

The hydraulic lockout control is shown in the LOCKED position. For further details on this procedure, refer to Operation and Maintenance Manual, "Hydraulic Lockout Control".

Perform Step 1 through Step 2 in order to open the upper window.




    Illustration 2g00107354

    (1) Grip

    (2) Latch

  1. Hold both grips (1), and push both latches (2) in order to unlatch the window.



    Illustration 3g00107355

  1. Lift the window upward until the window is securely latched in the overhead storage position.

    Perform Step 3 in order to close the upper window.

  1. Push both latches (2) in order to unlatch the window and lower the window into position until the latches engage.

    Perform Step 4 through Step 7 in order to open the lower window and close the lower window.




    Illustration 4g00555029

    (3) Latch

  1. Push both latches (3) in order to unlatch the lower window.

  1. Raise the lower window to the top of the upper window frame.

  1. Hold both grips (1) and release both latches (2) .

  1. Raise both windows until the windows are latched in the overhead storage position.

    Perform Step 8 through Step 11 in order to lower the windows.

  1. Push both latches (2) in order to unlatch the window.

  1. Lower the windows until latches (2) engage.

  1. Push both latches (3) in order to unlatch the lower window.

  1. Lower the lower window until latches (3) engage.

Information System:

3456 Engine for Caterpillar Built Machines System Configuration Parameters
5130B Excavator Lifting the Boom
312C and 312C L Excavator Lifting Capacities - 312C with a VA Boom
312C and 312C L Excavator Air Inlet Heater Starting Aid
325C Excavator Machine System Specifications Bucket
5130B Excavator Equipment Lowering with Engine Stopped
M318 Excavator Hydraulic System Swing Brake Pressure - Test
5230 Excavator Hydraulic System Relief Valve (Main) - Test - If Equipped
5230 Excavator Hydraulic System Control Valve (Front) - Type 2
325C Excavator Machine System Specifications Bucket
305 CR Mini Hydraulic Excavator Boom/Stick/Bucket Combinations
BH27, BH30 and BH30 W Skid Steer Loader Backhoes Swing Cylinder - Remove and Install
Quick Coupler Wedge Lock(Wheel Loader) Operating Technique Information
325C Excavator Machine System Specifications Bucket
312C and 312C L Excavator Specifications
3456 Engine for Caterpillar Built Machines E039 Low Engine Oil Pressure Derate
345B Series II Excavator Hydraulic System SmartBoom Hydraulic System
312C and 312C L Excavator VA Boom Controls
3456 Engine for Caterpillar Built Machines Sensors and Electrical Connectors
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Control Valve (Boom) (Mechanically Operated)
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Control Valve (Stick) (Mechanically Operated)
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Control Valve (Swing) (Mechanically Operated)
416D, 420D, 424D, 428D, 432D and 442D Backhoe Loaders Hydraulic and Steering System Control Valve (Stick) (Pilot Operated)
416D, 420D, 424D, 428D, 432D and 442D Backhoe Loaders Hydraulic and Steering System Control Valve (Swing) (Pilot Operated)