MP15, MP20, MP30 and MP40 Multi-Processors Bushings - Lubricate Caterpillar


Bushings - Lubricate
`
MP15, MP20, MP30 and MP40 Multi-Processors [SEBU7750]
FRAME AND BODY
HOUSING GP
MP15, MP20, MP30 and MP40 Multi-Processors Bushings - Lubricate

Note: Wipe all of the fittings before you lubricate the fittings.

Lubricate the fittings on the work tool. Refer to the following illustrations and tables for the locations of the lubrication points.



Illustration 1g02150061
MP15, MP20 and MP30

Table 1
MP15, MP20, and MP30 Multi-Processors 
Lubrication Points  Number of Fittings  Callout 
Cylinder Rod  LP1 
Cylinder Pin  LP3 
Frame Pin  LP4 
Cylinder Bearing  LP5 


Illustration 2g02150062
MP40

Table 2
MP40 Multi-Processors 
Lubrication Points  Number of Fittings  Callout 
Cylinder Rod  LP1 
Cylinder Pin  LP4 
Frame Pin  LP5 
Cylinder Bearing  LP6 

Refer to the Special Publication, SEBU6250, "AVSpare Machine Fluids Recommendations" for information on lubricants.

Information System:

C9.3 Engines for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
349E Excavator Hydraulic System Return Hydraulic System
C6.6 Industrial Engine Flywheel Housing - Remove and Install - Standard Housing
C6.6 Industrial Engine Crankshaft Rear Seal - Install
C6.6 Industrial Engine Crankshaft Rear Seal - Remove
C6.6 Industrial Engine Flywheel - Install
C6.6 Industrial Engine Flywheel - Remove
C6.6 Industrial Engine Water Temperature Regulator - Remove and Install
C6.6 Industrial Engine Water Pump - Install
C6.6 Industrial Engine Water Pump - Remove
C6.6 Industrial Engine Engine Oil Pump - Install
C6.6 Industrial Engine Engine Oil Pump - Remove
MP15, MP20, MP30 and MP40 Multi-Processors Rotator Gear - Lubricate
MP15, MP20, MP30 and MP40 Multi-Processors Cutting Edges - Inspect/Replace
Improved Jacket Water Circuit Breaker for Certain Electric Power Generators and Work Tools{1383, 1417, 1420}
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems Stick - Remove and Install
C9.3 Engines for Caterpillar Built Machines Inlet Manifold - Remove and Install
2010/05/20 An Improved Hydraulic Tank is Available for Certain Excavators {5056}
2010/05/06 Improved Remanufactured Injectors Are Now Used on Some 3408E and 3412E Machine Engines {1251, 1254, 1290, 1713}
C13 Tier 4 Final Engines Exhaust Cooler (NRS) - Clean
MP15, MP20, MP30 and MP40 Multi-Processors Rotator Head Bolts - Check
MP15, MP20, MP30 and MP40 Multi-Processors Rotator Head Bolts - Check
MP15, MP20, MP30 and MP40 Multi-Processors Rotator Head Bolts - Check
C15 and C18 Tier 4 Final Engines Exhaust Cooler (NRS) - Test