Cat Detect Object Detection System Software Version 3 for Certain Wheel Loaders, Wheel Dozers, Quarry Trucks, Off-Highway Truck/Tractors, Motor Graders, and Articulated Trucks Object Detection Sensor - Clean/Inspect Caterpillar

Show/hide table

Improper operation of an access platform could result in injury or death. Operators must carry out their duties properly and follow all instructions and guidelines given for the machine and access platform.

Show/hide table

Be sure all personnel are clear of the equipment while the equipment is being lowered. Failure to stay clear of the equipment while the equipment is being lowered may result in personal injury.

Inspect and clean the object detection sensors at the beginning of each shift. Refer to the following list for inspecting and cleaning the object detection sensors.

Note: When you access the object detection sensors for cleaning or inspection, be sure to observe safe procedures for access. Maintain a three-point contact and/or use a body harness.

Inspect

1. Inspect the brackets and the covers of the object detection sensors.

   1. Inspect the covers of the object detection sensors for cracks or damage.

      Note: When a cover for the object detection system has been damaged, replace the cover.

   2. Ensure that the mounting bolts are tight.

   3. Verify that there is no damage to the object detection system and camera brackets or the object detection sensors.

   4. Visibly check the angles of the object detection system boxes. If the object detection system boxes appear to have moved or have been knocked out of alignment contact service personnel.
   Show/hide table

   Illustration 1	g03342860
   (1) Alignment Marks for Elevation (2) Alignment Marks for Azimuth

2. Check the object detection sensors for an excessive amount of mud or other materials around the object detection sensors.

   Note: When the object detection sensors are covered with mud or other debris, clean the cover of the object detection system detector and/or remove debris.

3. Inspect the breather tubes on the bottom of the object detection system boxes for debris. Remove any debris that exists in the breather tubes.

Cleaning Instructions

If necessary, use a damp cloth to clean the glass of the object detection sensors. The covers of the object detection sensors are not affected by a wash with a high-pressure spray.