 | |
| Illustration 1 | g02115796 |
Typical example | |
There are several specific safety messages on this work tool. The exact location of the safety messages and the description of the safety messages are reviewed in this section. Please become familiarized with all safety messages.
Make sure that all of the safety messages are legible. Clean the safety messages or replace the safety messages if the illustrations are not legible. When you clean the safety messages, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the safety messages. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the safety message. Loose adhesive will allow the safety message to fall.
Replace any safety message that is damaged, or missing. If a safety message is attached to a part that is replaced, install a safety message on the replacement part. Any Verachtert dealer can provide new safety messages.
Do Not Operate(1)
 | |
| Illustration 2 | g01370904 |
The safety message is located on both sides of the multi-processor.
 |
Do not operate or work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Verachtert dealer for replacement manuals. Proper care is your responsibility. |
 |
Crushing Hazard(2)
 | |
| Illustration 3 | g01378775 |
The safety message is located on both sides of the multi-processor.
|
No clearance for person in this area during operation. Severe injury or death from crushing could occur. Stay away from the work tool while it is in operation. |
|
Flying Debris(3)
 | |
| Illustration 4 | g01392519 |
The safety message is located on both sides of the multi-processor.
|
Cab should have protective grill and operator should wear safety hat and safety glasses. Flying debris from the work tool could cause serious injury or death. |
|