326F Excavator Hydraulic System Oil Filter (Pilot)

Hydraulic System Oil Filter (Pilot) - Replace

326F Excavator [SEBU8091]

326F Excavator Hydraulic System Oil Filter (Case Drain) - Replace

HYDRAULIC SYSTEM

FILTER GP

349F and 352F Excavators Hydraulic System Oil Filter (Return) - Replace

326F Excavator Hydraulic System Oil Filter (Pilot) - Replace

326F Excavator Hydraulic System Oil Filter (Case Drain) - Replace

320E and 323E Excavators Oil Filter (Hydraulic Hammer) - Replace

Show/hide table

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.

Show/hide table




Illustration 1	g02022844

Park the machine on level ground. Lower the bucket to the ground so that the stick is vertical.
Move the hydraulic lockout control to the UNLOCKED position.
Turn the engine start switch to the ON position.
Move the joysticks and the travel levers/pedals to the full stroke positions in order to relieve the pressure in the pilot lines.

Turn the engine start switch to the OFF position and return the lever for the hydraulic lockout control to the LOCKED position.

Show/hide table




Illustration 2	g02024028

Show/hide table

Pressurized system!

The hydraulic tank contains hot oil under pressure. To prevent burns from the sudden release of hot oil, relieve the tank pressure with the engine off by slowly turning the cap approximately 1/8 of a turn until the cap reaches the secondary stop.

Show/hide table




Illustration 3	g02275615
Filler cap (A) LOCK position (B) PRESSURE RELEASE - START position (C) PRESSURE RELEASE - END position (D) OPEN position

Release the pressure that may be present in the return hydraulic circuit with the following procedure. Refer to Illustration 3 for filler cap positions.
1. Turn the filler cap counterclockwise, with no downward force applied, and move the arrow from position (A) to position (B).
2. Release the pressure for a minimum of 45 seconds by moving the arrow from position (B) to position (C).
3. Push the center of the filler cap down. Without tilting the filler cap, move the arrow from position (C) to position (D).
4. The hydraulic tank pressure is relieved. The filler cap can now be removed if needed.
5. Tighten the filler cap on the hydraulic tank to position (A).
Open the access door on the right side of the machine.
Show/hide table

Illustration 4 g02160117
Clean the area in order to keep dirt out of the filter base.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
Remove the used pilot filter element from the filter base.
Note: Used filters should always be disposed of according to local regulations.
Clean the filter base.
Show/hide table

Illustration 5 g00101502
Coat the seal of a new pilot filter with clean hydraulic oil.
Install the new oil filter by hand.
Instructions for the installation of the filter are printed on the side of each Cat spin-on filter. For filters that are not Cat branded, refer to the installation instructions that are provided by the supplier of the filter.
Check the hydraulic oil level.
Reference: For the correct procedure, refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".
Close the access door.