Stopping the Engine
`
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators
[SEBU8574]
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators
Air Conditioning and Heating Control
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators
Capacities (Refill)
ENGINE ARRANGEMENT
1.1. Engine Stop Control
Show/hide table
| NOTICE |
|---|
Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of engine components. Refer to the following procedure to allow the engine to cool and to prevent excessive temperatures in the turbocharger housing, which could cause oil coking problems. |
- Stop the machine and lower the work tool to the ground.
- Move the hydraulic lockout control to the LOCKED position.
- Run the engine at low idle for 5 minutes.
- Turn the engine start switch to the OFF position and remove the engine start switch key.
Engine Stop Control
Turn the engine start switch to the OFF position. If the engine does not stop, perform the following procedure.
- The switch is located below the left side of the operator seat.
Show/hide table
 | |
| Illustration 1 | g02161376 |
- Lift cover (1) .
Show/hide table
 | |
| Illustration 2 | g02161377 |
- Push switch (2) upward. The engine should stop.
Note: Use the engine start switch to stop the engine first. Use the engine stop control as an alternate method to stop the engine.
- Return the switch to the original position. The engine will be enabled to start.
Note: Do not operate the machine again until the malfunction has been corrected.
Information System:
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators
Air Conditioning and Heating Control
C9.3 Engines for Caterpillar Built Machines
Unit Injector - Remove
374F Excavator Hydraulic System
Travel Motor
C4.4 Industrial Engine
Air Inlet and Exhaust System - Inspect
374D Excavator Hydraulic System
Relief Valve (Swing)
C13, C15, and C18 Tier 4 Interim Engines
Cat ET Service Features
Idler Oil Fill Volume {4159, 4159}
329E Excavator
Specifications
M300D Wheeled Excavator Transmission Speed Sensor Causes Error Codes{3030}
329E Excavator
Boom/Stick/Bucket Combinations
349F and 352F Excavators Machine System Specifications
Window Wiper and Washer
Using the <NOBR> 6V-7840</NOBR> Deck Checking Tool Assembly {0701, 1201, 7225}
320E and 323E Excavators
Safety Messages
318E Excavator
Additional Messages
C9.3 Engines for Caterpillar Built Machines
Unit Injector - Install
374D Excavator Hydraulic System
Return Hydraulic System
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators
Capacities (Refill)
374D Excavator Hydraulic System
Oil Makeup (Swing System)
320 VH and VM Variable Gauge Undercarriage
Track - Separate
320 VH and VM Variable Gauge Undercarriage
Track - Connect
374F Excavator Hydraulic System
Displacement Change Valve
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Main Control Valve - Remove
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Main Control Valve - Install
374F Excavator Hydraulic System
Travel Counterbalance Valve