320E and 323E Excavators Fuel System Secondary Filter

Fuel System Secondary Filter - Replace

320E and 323E Excavators [SEBU8583]

320E and 323E Excavators Safety Messages

320E and 323E Excavators Specifications

FUEL SYSTEM

FILTER GP-FUEL

966M and 972M Wheel Loaders Fuel System - Prime

320E and 323E Excavators Fuel System Secondary Filter - Replace

Show/hide table

Personal injury or death can result from a fire.
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.
Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system.

Turn the disconnect switch OFF or disconnect the battery when changing fuel filters.

Show/hide table

NOTICE

Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.

Show/hide table

NOTICE

Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component.

Open access door on the left side of the machine.
Show/hide table

Illustration 1 g02709857
Loosen drain valve (2) and allow the fuel to drain out of the housing.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
After all the fuel has been removed, tighten the drain.
Remove the secondary fuel filter housing (1) from the base.
Remove the filter element from the housing.
Clean the filter housing and the base.
Install the new filter element into the housing.
Show/hide table

Illustration 2 g00101318
Apply a thin coat of clean diesel fuel to the sealing surface of the new fuel filter.
Install the new filter by hand until the filter housing contacts the base.
Prime the fuel system. See Operation and Maintenance Manual, "Fuel System - Prime" for instructions.
Close the access door on the left side of the machine.