S365C and S385C Demolition and Scrap Shears Cutting Edge Bolts

Cutting Edge Bolts - Tighten

S365C and S385C Demolition and Scrap Shears [SEBU8485]

S365C and S385C Demolition and Scrap Shears Cutters - Inspect/Replace

S365C and S385C Demolition and Scrap Shears Jaw - Repair

WORK TOOLS

GROUND ENGAGING TOOLS (G.E.T.)

S365C and S385C Demolition and Scrap Shears Cutters - Inspect/Replace

S365C and S385C Demolition and Scrap Shears Cutting Edge Bolts - Tighten

S365C and S385C Demolition and Scrap Shears Wear Plates - Inspect/Replace

On a machine, position the shear vertically with the fixed jaw on a flat and a level surface.

Lock the jaws in an open position. Refer to Operation and Maintenance Manual, "Cutters - Inspect/Replace" for the proper procedure.

Show/hide table




Illustration 1	g02181274

Check all of the bolts for the cutting edge group for the correct tightness. Refer to illustration 1.

If necessary, tighten the bolts to the proper torque value. Refer to table 1 for the correct torque values.

Show/hide table

Table 1
Static inspection torque for the cutting edge gp bolts
Blades	Sales Model	Bolt Size	Torque Value
Cross Blade	S365C, S385C	M20 x 2.5	450 N·m (330 lb ft)
Cutting Blades	S365C, S385C	M20 x 2.5	450 N·m (330 lb ft)
Guide Blades	S365C, S385C	M20 x 2.5	450 N·m (330 lb ft)
Piercing Blades	S365C	M20 x 2.5	450 N·m (330 lb ft)
Piercing Blades	S385C	M24 x 2.5	800 N·m (590 lb ft)

The bolts should not move before a torque that is specified in table 1 is reached. If the bolt moves, then the bolt has been overstressed. The bolt must then be replaced.

ReferenceRefer to Operation and Maintenance Manual, "Cutters - Inspect/Replace" for information on replacing the bolts for the cutting edge group.