328D CR Excavator Lifting and Tying Down the Machine - Rear Eyes and Front Eyes Caterpillar

Lifting and Tying Down the Machine - Rear Eyes and Front Eyes

328D CR Excavator [SEBU8181]

328D CR Excavator Declaration of Conformity

328D CR Excavator Joystick Controls Alternate Patterns

MACHINE ARRANGEMENT

322B, 322B L, 325B and 325B L Excavators Towing the Machine

322B, 322B L, 325B and 325B L Excavators Lubricant Viscosities - Fluids Recommendations

322B, 322B L, 325B and 325B L Excavators Operation

1.1. Lifting the Machine Segments

2.2. Bucket

Show/hide table




Illustration 1	g02176524

Show/hide table

NOTICE

Improper lifting and improper tie-downs can allow the load to shift and cause injury or damage.

Note: The shipping weight that is listed is the weight of the most common configuration of the machine. If attachments have been installed on your machine, the weight of your machine and the center of gravity of your machine may vary.

Refer to the Operation and Maintenance, "Specifications" for specific weight information.

Use proper rated cables and slings for lifting. The crane should be positioned so that the machine is lifted parallel to the ground.
To prevent contact with the machine, lifting cables should have sufficient length.
Use the rear eyes and the front eyes that are provided on the lower frame to fasten tie-downs. Use corner protectors for sharp corners.
Move the hydraulic lockout control to the LOCKED position.

Lifting the Machine Segments

Bucket

Show/hide table




Illustration 2	g01587173
(1) Sleeve (2) Bolts (3) Pin (4) Nuts

Install pin (3) and install sleeve (1) in the brackets of the bucket. The previous illustration indicates the method to secure pin (3) with bolts (2) and nuts (4). Fasten two proper rated wire cables to pin (3).

Note: Never use the step when the machine is lifted.