 | |
| Illustration 1 | g00822453 |
(1) Tighten the bolts to 420 ± 60 N·m (310 ± 44 lb ft). Tighten the bolts to an additional 60° ± 5°.
(2) Apply 1U-8846 Gasket Sealant to the flange of the gear.
(3) After installing the six pins, stake the pins at two places. Refer to View A for the location of the stake marks.
Use the following procedure to adjust the preload of bearing (4) :
- Place a load "P" of 4000 kg (8820 lb) on bearing (4) .
- Rotate the housing (10) in order to seat the bearing.
- Reduce load "P" to 1000 ± 100 kg (2200 ± 220 lb).
- Measure dimension (A) .
- Measure dimension (B) on the stopper (8) .
- Calculate the installation dimension (C) by subtracting dimension (B) from dimension (A) .(C=A-B).
- Apply 9S-3263 Thread Lock Compound to threads and install the stopper to the installation dimension (C) at ± 0.05 mm (± 0.002 inch).
- After adjustment, stake the flange of the stopper (8). This will help to place the stopper in the groove of the thread of the housing (10) .
(4) Apply 5P-3931 Anti-Seize Compound to the surfaces that are in contact with the bearings.
(5) At assembly, O-rings of floating seal and all surfaces in contact with the O-rings must be clean and dry. Apply a thin coat of oil on the contacting surfaces of the metal seals before installation.
(6) Install the proper plate for a clearance (X) of 2.0 mm (0.08 inch). Refer to Illustration 2.
 | |
| Illustration 2 | g00759574 |
Measure dimension (D). Measure dimension (E). Refer to Illustration 2. Calculate the clearance (X) by subtracting dimension (E) from dimension (D). (X=D-E).
(6) 094-0578 Plate
- Thickness of plate ... 8.0 ± 0.2 mm (0.30 ± 0.01 inch)
-
094-0579 Plate
- Thickness of plate ... 9.0 ± 0.2 mm (0.35 ± 0.01 inch)
-
094-0580 Plate
- Thickness of plate ... 10.0 ± 0.2 mm (0.39 ± 0.01 inch)
(7) Torque for plug ... 80 ± 10 N·m (60 ± 7 lb ft)