C4.4 Industrial Engine Air Compressor - Single Cylinder Caterpillar


Air Compressor - Single Cylinder
`


Illustration 1g02148439
Typical example

(1) Tighten the nut to the following torque. ... 120 N·m (89 lb ft)



Illustration 2g02148442
Typical example

(2) Tighten the nuts to the following torque. ... 78 N·m (58 lb ft)

(3) Tighten the bolts to the following torque. ... 44 N·m (32 lb ft)



Illustration 3g02148447
Typical example

(4) Tighten the bolts to the following torque. ... 22 N·m (16 lb ft)

(5) Tighten the bolts to the following torque. ... 44 N·m (32 lb ft)

(6) Tighten the banjo bolt to the following torque. ... 9 N·m (80 lb in)

For the correct procedure to install the air compressor, refer to Disassembly and Assembly, "Air Compressor - Remove and Install - Single Cylinder".

Information System:

C4.4 Industrial Engine Air Compressor - Twin Cylinder Compressor
374D Excavator Machine System Specifications Bucket Linkage - VB Family
Procedure to Install <NOBR>214-3287</NOBR> Drain Lines Group on Certain C, D, E, F, and Next Generation Series Excavators {0679, 5057}
303.5D, 304D, 305.5D and 305D Mini Hydraulic Excavators Engine Supplement Muffler - Remove and Install
348-5430 Multi-Tool Gp 2 {0709, 0769, 0785}
317-7492 Wireless Radio{7338}
303.5D, 304D, 305.5D and 305D Mini Hydraulic Excavators Engine Supplement Fuel Filter and Water Separator Base - Remove and Install
VHC-30, VHC-40, VHC-50 and VHC-60 Hydraulic Crushers Ripper Tooth - Remove and Install
349E Excavator Hydraulic System Swing Motor - Test - Measurement of Case Drain Oil
VHC-30, VHC-40, VHC-50 and VHC-60 Hydraulic Crushers Crusher Tooth - Remove and Install
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems Stick Cylinder - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
568 Forest Machine Hydraulic System Swing Speed and Swing Drift on a Slope - Check
568 Forest Machine Hydraulic System Cylinder Drift - Check - Loaded Bucket/Heel
C9.3 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C13 Engines for Caterpillar Built Machines Turbocharger - Inspect
2010/04/29 The Frame of the Center Lock Pin Grabber Quick Coupler was Redesigned for Certain Excavators {6129}
374F Excavator Machine System Boom Lines
2010/07/27 A New Recoil Spring is Now Used on Certain 320D Excavators {4157, 4158}
C4.4 Industrial Engine Cylinder Head - Inspect
C4.4 Industrial Engine Engine Oil Cooler - Inspect
C4.4 Industrial Engine Engine Valve Lash - Inspect
349F and 352F Excavators Hydraulic System Pump Control (Output Flow) - Adjust
568 Forest Machine Hydraulic System Cylinder Drift - Check - Empty Bucket