C13 Engines for Caterpillar Built Machines Temperature Sensor (DPF Inlet, Flame Detect) Caterpillar


Temperature Sensor (DPF Inlet, Flame Detect)
`
C13 Engines for Caterpillar Built Machines [UENR0945]
ELECTRICAL AND STARTING SYSTEM
SENSOR GP
C15 Petroleum Generator Set Engines Speed/Timing Sensor
C13 Engines for Caterpillar Built Machines Temperature Sensor (DPF Inlet, Flame Detect)


Illustration 1g02560180
(1) Exhaust combustion group
(3) Diesel particulate filter group

Table 1
Specification for 341-4176 Temperature Sensor Gp 
Item  Qty  Part  Specification Description 
341-4176 Temperature Sensor Gp  Torque to 45 ± 5 N·m (33 ± 4 lb ft).
Before installing the sensor into the Diesel Particulate Filter (DPF), apply the anti-seize compound to the threads of the sensor. Also apply the anti-seize compound to the threads that the sensor will be installed into. Use Never Seez from Bostik “Pure Nickel Special” anti-seize compound. 
Output type is analog/ powered passive. 
Operating voltage is 5.00 ± 0.25 VDC. 

Note:

Information System:

C6.6 Industrial Engine Valve Mechanism Cover - Remove and Install
C6.6 Industrial Engine Crankcase Breather - Install
C6.6 Industrial Engine Crankcase Breather - Remove
C6.6 Industrial Engine Accessory Drive - Remove and Install - Accessory Drive SAE "B"
C6.6 Industrial Engine Accessory Drive - Remove and Install - Accessory Drive SAE "A"
C6.6 Industrial Engine Housing (Front) - Install - Heavy Duty Housing (Front)
C6.6 Industrial Engine Housing (Front) - Install
2010/05/13 The Gas Strut on Backhoe Loader Steering Columns Has Been Improved {4309, 4310, 4338}
C6.6 Industrial Engine Housing (Front) - Remove - Heavy Duty Housing (Front)
C6.6 Industrial Engine Housing (Front) - Remove
C6.6 Industrial Engine Idler Gear - Install
C6.6 Industrial Engine Idler Gear - Remove
C6.6 Industrial Engine Rocker Shaft and Pushrod - Remove
C6.6 Industrial Engine Rocker Shaft - Disassemble
MP15, MP20, MP30 and MP40 Multi-Processors Wear Tip - Inspect/Replace
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems Pilot Valve (Travel) - Disassemble
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems Pilot Valve (Travel) - Assemble
Removing the 2W-1055 Elbow {1307}
349E Excavator Hydraulic System Specifications
C15 and C18 Engines for Caterpillar Built Machines Exhaust Elbow - Remove and Install
324E Excavator Declaration of Conformity
C9.3 Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C6.6 Industrial Engine Rocker Shaft - Assemble
C6.6 Industrial Engine Rocker Shaft and Pushrod - Install