Pilot Lines - System 20
`
312D and 313D Excavators Machine System Specifications
[KENR6553]
312D and 313D Excavators Machine System Specifications
Front Lines
312D and 313D Excavators Machine System Specifications
Front Lines - System 22
HYDRAULIC SYSTEM
LINES GP-HYDRAULIC
311D Excavator Machine System Specifications
Pilot Lines
312D2 and 313D2 Excavators Machine System Specifications
Pilot Lines - Joystick and Main Control Valve
312D and 313D Excavators Machine System Specifications
Pilot Lines - Pump
312D and 313D Excavators Machine System Specifications
Pilot Lines - Main Control Valve and Manifold
314D CR Excavator Machine System Specifications
Stick Cylinder Lines
312D and 313D Excavators Machine System Specifications
Pilot Lines - System 23
Show/hide table
![]() | |
Illustration 1 | g02578037 |
Rear view |
Show/hide table
Specification for 278-6695 Pilot Lines Gp     | |||
Item     | Qty     | Part     | Specification Description     |
Sharp corners at the cutting edge of each cable strap shall not be allowed.     | |||
1     | 1     | 148-8336 Connector As     | Torque to 29 ± 3 N·m (257 ± 27 lb in).     |
2     | 1     | 148-8378 Elbow As     | Torque to 40 ± 5 N·m (30 ± 4 lb ft).     |
3     | 1     | 150-3036 Elbow As     | Torque to 40 ± 5 N·m (30 ± 4 lb ft).     |
4     | 1     | 309-5769 Pressure Switch     | Torque to 29 ± 3 N·m (257 ± 27 lb in).     |
5     | 2     | 5C-9553 Bolt     | Torque to 9.8 ± 1.5 N·m (86.7 ± 13.3 lb in).     |
6     | 3     | 148-8378 Elbow As     | Torque to 24 ± 2 N·m (212 ± 18 lb in).     |
Information System:
349E Excavator Hydraulic System
Solenoid Valve (Fine Swing) - If Equipped
312D and 313D Excavators Machine System Specifications
Front Lines
312D and 313D Excavators Machine System Specifications
Control Valve - Two Pump One Way Flow
312D and 313D Excavators Machine System Specifications
Pilot Lines - System 23
S365C and S385C Demolition and Scrap Shears
Jaw - Repair
S365C and S385C Demolition and Scrap Shears
Cutting Edge Bolts - Tighten
S365C and S385C Demolition and Scrap Shears
Cutters - Inspect/Replace
C27 and C32 Generator Set Engines
Fuel Lines - Remove and Install
Product Link - PL522/523
Diagnostic Capabilities
S365C and S385C Demolition and Scrap Shears
Lifting and Tying Down
S365C and S385C Demolition and Scrap Shears
Transport Position - Transport of shear on host machine
S365C and S385C Demolition and Scrap Shears
Operation
Product Link - PL522/523
Event Code List
Product Link - PL522/523
Electronic Service Tool Does Not Communicate with ECM
349E Excavator Hydraulic System
Travel Hydraulic System
Rework Procedure for the Insulation Group Around the Cooling Arrangement for 307D Excavators{7150, 7251, 726A, 7276, 7301}
Product Link - PL522/523
Reports and Messages Not Available
374D Excavator Hydraulic System
Specifications
312D and 313D Excavators Machine System Specifications
Front Lines - System 22
C4.4 Industrial Engine
Engine Oil Pump - Inspect
312D and 313D Excavators Machine System Specifications
Pump Lines (Auxiliary)
312D2 and 313D2 Excavators Machine System Specifications
Control Valve
Crimputer III Setup and Operation{0684, 5057}
Product Link - PL522/523
Position Reports Not Available