The machine control ECM monitors many functions on the excavator. Certain problems with the machine will not record a diagnostic code, but these problems will display a message on the display area. These problems are described below:
Communication Errors
The monitor communicates with the following components on the machine: Machine ECM, Engine ECM and Switch Panel. If the monitor loses contact with any of these components, the display shows one of the following messages:
![]() | |
Illustration 1 | g00834413 |
![]() | |
Illustration 2 | g00834420 |
![]() | |
Illustration 3 | g00834428 |
Monitor Error
![]() | |
Illustration 4 | g00834432 |
When the monitor has detected a problem with the monitor, the display will show the symbol for an error with the monitor.
CAN Data Link (Error)
![]() | |
Illustration 5 | g00834440 |
When the monitor is unable to communicate on the CAN data link, the display shows the symbol for an error on the CAN data link.