538 Forest Machine Machine Systems Swing Speed and Swing Drift on a Slope

Table 1
"Swing Speed and Swing Drift on a Slope - Check"
Swing Time (seconds)
Item	538 GF	538 LL	Actual
Right Swing	3.5 or less	3.5 or less
Left Swing	3.5 or less	3.5 or less
Swing Drift mm (inch)
Item	538 GF	538 LL	Actual
Right Swing	0	0
Left Swing	0	0

Measuring the swing speed on a slope will determine if there is a need to check the swing motor and the anti-reaction valve. Measuring the swing drift on a slope will determine if there is a need to check the swing parking brake.

Note: The engine speed and/or the machine configuration that is used during this test can affect the results of this test. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for the engine speed that was used for this test. Refer to Testing and Adjusting, "Operational Checks" for the machine configurations that were used for this test.

Note: The relief valve pressure settings must be set to the relief valve pressure specification before performing this operational check. Refer to Testing and Adjusting, "Specifications".

Required Tools

Show/hide table

Table 2
Description	Qty
Measuring Tape	1
Stopwatch	1

Test Procedure

Swing Speed on a Slope

Show/hide table




Illustration 1	g01404840

Complete the following steps to measure the swing speed on a slope.
1. The heel should be empty.
2. Position the machine on a slope of 12 degrees. Refer to Illustration 1.
3. Position the implements at maximum reach and close the heel. Position the heel above the ground so that the heel will not come in contact with any obstacles.
  Show/hide table
  
  Illustration 2 g01404841
4. Position the upper structure at position (A). The upper structure should be at a 90 degree angle to the lower structure. Refer to Illustration 2.
5. Measure the time that is required to swing the upper structure from position (A) to position (B).
6. Position the upper structure at position (C). The upper structure should be at a 90 degree angle to the lower structure.
7. Measure the time that is required to swing the upper structure from position (C) to position (B).

Swing Drift on a Slope

Complete the following steps to measure the swing drift on a slope.
1. Position the upper structure at position (A). The upper structure should be at a 90 degree angle to the lower structure. Refer to Illustration 3.
  Show/hide table
  
  Illustration 4 g00293972
  
  (A) Upper frame
  (B) Undercarriage frame
  (C) Marking
2. To indicate the relationship of the two positions, put a mark (C) on the inner race and the outer race of the swing bearing. Refer to Illustration 4.
3. Stop the engine.
4. Leave the machine in this position for three minutes. Measure the swing drift on the circumference of the swing bearing.
5. Start the engine.
6. Position the upper structure at position (C). The upper structure should be at a 90 degree angle to the lower structure. Refer to Illustration 3.
7. Repeat Steps 1.b through 1.d.