System Operation Description:
Power to the ECM can fail due to an open circuit in the wire, or a blown fuse. A fuse is blown out as a result of an overloaded circuit. For example, the +battery connection is shorted to ground.
Test Step 1. CHECK THE ECM FOR POWER AND GROUND.
At the ECM, measure the voltage from contact J1-31 to contact J1-38.
Expected Result:
The voltage is system voltage.
Results:
- OK - The voltage is system voltage. The power supply circuit to the ECM is correct. STOP
- NOT OK - The voltage is not system voltage. Proceed to Test Step 2.
Test Step 2. CHECK THE FUSE
When an electronic component fails to function, check the fuse for the ECM that controls the component.
- Check the fuse for the ECM. The wire to the fuse for the electronic control is 126-RD.
Expected Result:
The fuse is correct.
Results:
- YES - The fuse is correct. Proceed to Test Step 3.
- NO - The fuse is not correct.
Repair: Replace the blown fuse or reset the circuit breaker. Observe the machine for a recurrence of the problem. If the problem persists, the reason for the blown fuse must be isolated and corrected.
STOP
Test Step 3. CHECK THE POWER WIRE TO THE ECM.
- Turn the key start switch and the disconnect switch to the OFF position.
- At the fuse, connect the lead from the multimeter to wire 126-RD.
- At the ECM, connect the other lead from the multimeter to the following contacts and measure the resistance: 38 and 39.
Expected Result:
The resistance is less than 5.0 ohms.
Results:
- OK - The resistance is less than 5 ohms. The wiring circuit is correct. Proceed to Test Step 4.
- NOT OK - The resistance measurement to one or more of the contacts is greater than 5.0 ohms. The wiring has an open circuit.
Repair: Repair the wiring harness or replace the wiring harness.
STOP
Test Step 4. CHECK THE ECM GROUND CONNECTIONS.
- The key start switch and the disconnect switch remain in the OFF position.
- At the ECM, measure the resistance from 13, 23 and 57 to frame ground.
Expected Result:
The resistance is less than 5.0 ohms.
Results:
- OK - The resistance is less than 5 ohms. The ground circuit is correct. The ECM may have failed. An ECM failure is unlikely. Perform this procedure again. If the problem remains, the ECM may have failed. Contact your dealerships for possible consultation with AVSpare. This consultation may greatly reduce repair time.STOP
- NOT OK - The resistance is greater than 5.0 ohms. The ground circuit has failed.
Repair: The ground circuit has failed. Repair the wiring harness or replace the wiring harness.
STOP