Engine Shutdown While Idling
`
C9.3 Engines for Caterpillar Built Machines
[KENR5393]
C9.3 Engines for Caterpillar Built Machines
Intake Manifold Air Pressure Is Low
C9.3 Engines for Caterpillar Built Machines
Fuel Pressure Is High
ELECTRICAL AND STARTING SYSTEM
ELECTRONICS GP-ENGINE
C9.3 Engines for Caterpillar Built Machines
Event Codes
C9.3 Engines for Caterpillar Built Machines
Symptom Troubleshooting
C9.3 Engines for Caterpillar Built Machines
Engine Monitoring System
C9.3 Engines for Caterpillar Built Machines
Diagnostic Capabilities
C9.3 Engines for Caterpillar Built Machines
ECM Software - Install
C9.3 Engines for Caterpillar Built Machines
Electronic Service Tool Does Not Communicate
C9.3 Engines for Caterpillar Built Machines
Test ECM Mode
Use this procedure if one of the following event codes is active. Refer to Troubleshooting, "Event Codes" for information about event codes.
Show/hide table
| Event Code | ||
|---|---|---|
| CDL Code | Description | Comments |
| E1171 (1) | Engine Idle Shutdown Occurred | The engine has been idling for an extended amount of time.
This notification is for the operator. This notification is not a suspected engine problem. The code is logged. |
| E1172 (3) | Engine Idle Shutdown Pending | The engine is shutting down.
An alarm will sound. The code is logged. |
- Extended idle time
Show/hide table
| Troubleshooting Test Steps | Values | Results |
1. Engine At Idle Speed A. This condition is normal operation. The engine has been idling for an extended amount of time and the Electronic Control Module (ECM) will shutdown the engine. B. The "Engine Idle Shutdown Enable Status" parameter in AVSpare Electronic Technician (ET) can be disabled. The amount of time before engine shutdown can then be configured. |
Normal Operation |
Result: This condition is normal operation. Return the unit to service. |
Information System:
C9.3 Engines for Caterpillar Built Machines
Intake Manifold Air Pressure Is Low
358-4528 (380/480 V, 50/60 Hz, 3 Phase), 457-6040 (230V, 60 Hz, Single Phase) , 457-6039 (230V, 50 Hz, Single Phase) Hose Machine Group Set-Up and Operation{0599, 0684}
C9.3 Engines for Caterpillar Built Machines
Intake Manifold Air Temperature Is High
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Support (Swing Boom) - Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Support (Swing Boom) - Remove
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Boom - Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Boom - Remove
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Swing Boom Cylinder - Remove and Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Boom Cylinder - Remove and Install
C13, C15, and C18 Engines for Caterpillar Built Machines
Event Codes
C13, C15, and C18 Engines for Caterpillar Built Machines
Diagnostic Trouble Codes
Reusability Inspection of Seal Ring and Stator Carrier Assemblies for Certain Models {0669, 0760, 0761, 3101, 3129, 3160, 7555}
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Heating and Air Conditioning Unit - Remove
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Heating and Air Conditioning Unit - Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Blower Motor (Air Conditioner, Heater) - Remove and Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Evaporator Coil - Remove and Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Sprocket - Remove and Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Recoil Spring - Remove and Install
C9.3 Engines for Caterpillar Built Machines
Fuel Pressure Is High
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Final Drive and Travel Motor - Remove
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Final Drive and Travel Motor - Install
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Final Drive and Travel Motor - Disassemble
303.5D CR, 304D CR, 305D CR and 305.5D CR Mini Hydraulic Excavators Machine Systems
Final Drive and Travel Motor - Assemble
C9.3 Engines for Caterpillar Built Machines
Fuel Pressure Is Low