415F2 Industrial Loader Power Train Solenoid Valve (Transmission) - Remove and Install Caterpillar


Solenoid Valve (Transmission) - Remove and Install
`
415F2 Industrial Loader Power Train [M0067026]
POWER TRAIN
VALVE GP-SOLENOID
415F2 Industrial Loader Power Train Solenoid Valve (Transmission) - Remove and Install
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure



    Illustration 1g06041542

  1. Remove plate (2), and floor mat (1).


    Illustration 2g06041533

  2. Remove floor plate (3) and panel (4).


    Illustration 3g06041571

  3. Disconnect harness assemblies (5) and (6). Remove bolts (7). Remove solenoid valve (8).

Installation Procedure

  1. Install solenoid valve (8) in the reverse order of removal.

    1. Tighten bolts (7) in a crisscross pattern to a torque of 1 N·m (9 lb in). Retorque bolts (7) to a final torque of 8 N·m (71 lb in).

Information System:

349D2 MHPU Mobile Hydraulic Power Unit Machine System Fuel Tank
349D2 MHPU Mobile Hydraulic Power Unit Machine System Swing Motor Lines
GSH420, GSH425, GSH440, GSH520, GSH525, GSH455 and GSH555 Orange Peel Grapples Rotator Motor and Manifold - Assemble
349D2 MHPU Mobile Hydraulic Power Unit Machine System Boom Cylinder Lines
GSV520 and GSV525 Orange Peel Grapples Rotator Motor and Manifold - Disassemble
New Fuel Injection Pump Stop Solenoid is Available on Certain 3054C and C7.1 (Mech) Machine Engines {1251, 1259, 1264}
GSV520 and GSV525 Orange Peel Grapples Rotator Motor and Manifold - Remove and Install
C9.3 Tier 4 Final Engines Cylinder Head
C9.3 Tier 4 Final Engines Fuel Injection Pump
Installing the <NOBR>387-6450</NOBR> Ride Control Kit to a Machine That Does Not Have an ECM {5004}
Installing the <NOBR>387-6451</NOBR> Ride Control Kit to a Machine That Has an ECM {5004}
307E2 Mini Hydraulic Excavator Machine Systems Refueling Pump - Remove and Install
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Remove
325F Excavator Engine Supplement Engine - Remove and Install
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Disassemble
325F Excavator Machine Systems Fuel Tank - Remove and Install
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Assemble
330F MHPU Mobile Hydraulic Power Unit Engine Oil and Filter - Change
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Install
349D2 MHPU Mobile Hydraulic Power Unit Machine System Swing Gear and Bearing
Technical Analysis 1 (TA1) Visual Inspection for Generator Sets {0372, 1000, 7000, 753S, 7565}
Technical Analysis 1 (TA1) Visual Inspection for Hydraulic Hammers {0372, 1000, 7000, 753S, 7565}
GSV520 and GSV525 Orange Peel Grapples Hydraulic Rotator - Remove and Install
415F2 Industrial Loader Power Train Drive Shaft (Front) - Remove and Install