415F2 Industrial Loader Power Train Drive Shaft (Front) - Remove and Install Caterpillar


Drive Shaft (Front) - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
1U-7505  Hydraulic Jack 


    Illustration 1g01116830

    Note: Removal of guard (2) is optional for clearance purposes.

  1. Install Tooling (A) under guard (2). Remove bolts (1). Repeat for the other side. Use Tooling (A) to lower guard (2) to the ground. The weight of guard (2) is approximately 38 kg (85 lb).


    Illustration 2g01116832

  2. Remove bolts (3). Discard bolts (3).


    Illustration 3g01116843

  3. Remove bolts (5) and front drive shaft (4). Discard bolts (5).

Installation Procedure

  1. Install front drive shaft (4) in the reverse order of removal.

    1. Use new bolts for bolts (3) and bolts (5). Tighten bolts (3) and (5) to a torque of 28 ± 7 N·m (248 ± 62 lb in).

Information System:

GSV520 and GSV525 Orange Peel Grapples Hydraulic Rotator - Remove and Install
Technical Analysis 1 (TA1) Visual Inspection for Hydraulic Hammers {0372, 1000, 7000, 753S, 7565}
Technical Analysis 1 (TA1) Visual Inspection for Generator Sets {0372, 1000, 7000, 753S, 7565}
349D2 MHPU Mobile Hydraulic Power Unit Machine System Swing Gear and Bearing
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Install
330F MHPU Mobile Hydraulic Power Unit Engine Oil and Filter - Change
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Assemble
325F Excavator Machine Systems Fuel Tank - Remove and Install
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Disassemble
325F Excavator Engine Supplement Engine - Remove and Install
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Remove
415F2 Industrial Loader Power Train Solenoid Valve (Transmission) - Remove and Install
415F2 Industrial Loader Power Train Drive Shaft (Rear) - Remove and Install
349D2 MHPU Mobile Hydraulic Power Unit Machine System Track
415F2 Industrial Loader Power Train Tie Rod (Steering)(Front) - Remove and Install
415F2 Industrial Loader Power Train Final Drive Planetary - Remove and Install
330F MHPU Mobile Hydraulic Power Unit Maintenance Interval Schedule
Similar Product Support Literature Available For Military Machines {0374, 1000, 7000}
415F2 Industrial Loader Power Train Axle Housing and Flange - Remove
415F2 Industrial Loader Power Train Final Drive Planetary - Remove and Install - Front
304.5E XTC Mini Hydraulic Excavators Machine Systems Pilot Valve (Joystick) - Remove and Install
Installation Procedure to Retrofit a Boom Lowering Control Valve on Certain 325D Forestry Machines {5057, 5147, 5811}
415F2 Industrial Loader Power Train Axle Housing and Flange - Disassemble
415F2 Industrial Loader Power Train Axle Housing and Flange - Assemble