415F2 Industrial Loader Power Train Tie Rod (Steering)(Front) - Remove and Install Caterpillar


Tie Rod (Steering)(Front) - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
1P-2320  Combination Puller 

Start By:

  1. Remove the front tires and rims.


    Illustration 1g01117258


    Illustration 2g01517361

    Note: Record the measurement from the center of nut (1) to the steering cylinder before removal to maintain proper alignment after installation.

  1. Loosen nut (1) until flush with the end of tie rod (2).

  2. Loosen nut (3).

  3. Use Tooling (A) to disconnect tie rod (2). Remove nut (1) and tie rod (2).

Installation Procedure

  1. Install tie rod (2) in the reverse order of removal, adjusting to the correct length.

    1. Tighten nut (1) to a torque of 220 N·m (162 lb ft).

    2. Tighten nut (3) to a torque of 250 N·m (184 lb ft).

Information System:

349D2 MHPU Mobile Hydraulic Power Unit Machine System Track
415F2 Industrial Loader Power Train Drive Shaft (Rear) - Remove and Install
415F2 Industrial Loader Power Train Drive Shaft (Front) - Remove and Install
GSV520 and GSV525 Orange Peel Grapples Hydraulic Rotator - Remove and Install
Technical Analysis 1 (TA1) Visual Inspection for Hydraulic Hammers {0372, 1000, 7000, 753S, 7565}
Technical Analysis 1 (TA1) Visual Inspection for Generator Sets {0372, 1000, 7000, 753S, 7565}
349D2 MHPU Mobile Hydraulic Power Unit Machine System Swing Gear and Bearing
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Install
330F MHPU Mobile Hydraulic Power Unit Engine Oil and Filter - Change
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Assemble
325F Excavator Machine Systems Fuel Tank - Remove and Install
415F2 Industrial Loader Power Train Transmission (Direct Drive) - Disassemble
415F2 Industrial Loader Power Train Final Drive Planetary - Remove and Install
330F MHPU Mobile Hydraulic Power Unit Maintenance Interval Schedule
Similar Product Support Literature Available For Military Machines {0374, 1000, 7000}
415F2 Industrial Loader Power Train Axle Housing and Flange - Remove
415F2 Industrial Loader Power Train Final Drive Planetary - Remove and Install - Front
304.5E XTC Mini Hydraulic Excavators Machine Systems Pilot Valve (Joystick) - Remove and Install
Installation Procedure to Retrofit a Boom Lowering Control Valve on Certain 325D Forestry Machines {5057, 5147, 5811}
415F2 Industrial Loader Power Train Axle Housing and Flange - Disassemble
415F2 Industrial Loader Power Train Axle Housing and Flange - Assemble
415F2 Industrial Loader Power Train Axle Housing and Flange - Install
415F2 Industrial Loader Power Train Axle Shaft - Remove and Install
Installation Procedure to Retrofit a Boom Lowering Control Valve on Certain 568 LL Forestry Machines {1329, 1439, 1916, 1917, 1923, 1924, 5001, 5117, 5130, 5264, 5453}