415F2 Industrial Loader Power Train Steering Cylinder (Front) - Remove and Install Caterpillar


Steering Cylinder (Front) - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
1P-2320  Combination Puller 
Loctite 271 

Start By:

  1. Remove the front axle.


    Illustration 1g01117223


    Illustration 2g01117229

  1. Place front axle assembly (2) onto suitable cribbing. Loosen nut (1) from each side.

  2. Use Tooling (A) to disconnect tie rod (3). Remove nut (1) and remove tie rod (3). Repeat for the other side.


    Illustration 3g01117236

  3. Remove bolts (4) and remove steering cylinder (5).

Installation Procedure

  1. Install steering cylinder (5) in the reverse order of removal.

    1. Apply Tooling (B) to threads on bolts (4).

    2. Tighten bolts (4) to a torque of 460 N·m (340 lb ft).

    3. Tighten nut (1) to a torque of 220 N·m (162 lb ft).

Information System:

PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Sensor Signal (Analog, Active) - Test
340F Excavator Shipping the Machine
340F Excavator Guards - Operator Protection
GSV520 and GSV525 Orange Peel Grapples Hydraulic Cylinder - Remove and Install
325F Excavator Machine Systems Track - Separate
325F Excavator Machine Systems Track Roller - Remove and Install
415F2 Industrial Loader Power Train Drive and Steering Axle (Front) - Install
415F2 Industrial Loader Power Train Drive and Steering Axle (Front) - Remove
415F2 Industrial Loader Power Train Axle Housing (Differential and Bevel Gear) (Front) - Assemble
415F2 Industrial Loader Power Train Axle Housing (Differential and Bevel Gear) (Front) - Disassemble
Installation of the <NOBR>360-6218</NOBR> Electronic Control Wiring Gp on Certain Hydraulic Excavators {1408}
Installation of the <NOBR>327-7487</NOBR> Foot Pedal Gp on Certain Hydraulic Excavators {5258}
538, 548 and 558 Forest Machine Diagnostic Trouble Codes
538, 548 and 558 Forest Machine Event Codes
415F2 Industrial Loader Power Train Rear Axle - Remove
415F2 Industrial Loader Power Train Rear Axle - Install
415IL Backhoe Loader Power Train Axle Housing, Axle Shaft, and Wheel Flange - Remove - Rear Axle
415IL Backhoe Loader Power Train Axle Housing, Axle Shaft, and Wheel Flange - Disassemble - Rear Axle
352F Mobile Hydraulic Power Unit (MHPU) Machine Systems Specifications
GSV520 and GSV525 Orange Peel Grapples Bushings (Shell Assembly) - Remove and Install
C9 Engines for Caterpillar Built Machines Piston and Rings
Technical Analysis 1 (TA1) Visual Inspection for Paving Compactors {0372, 1000, 7000, 753S, 7565}
C9 Engines for Caterpillar Built Machines Cylinder Liner
349F XE and 352F XE Excavators Shipping the Machine