415IL Backhoe Loader Power Train Axle Housing, Axle Shaft, and Wheel Flange - Remove - Rear Axle Caterpillar


Axle Housing, Axle Shaft, and Wheel Flange - Remove - Rear Axle
`
1.1. Removal Procedure

Removal Procedure

Start By:

  1. Remove the rear axle.

  2. Remove final drive planetary.


NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.

Dispose of all fluids according to local regulations and mandates.


  1. Drain the oil from the axle. Refer to Operation and Maintenance Manual, SEBU9921, "Differential Oil (Rear) - Change".


    Illustration 1g03652780
    Picture for reference only

    Note: Put location marks on the axle housing, brake cylinder assemblies, and the center housing for assembly purposes.

  2. Position suitable cribbing under the axle to support the sections during removal. Attach a suitable lifting device onto axle housing, axle shaft, and wheel flange (3). The weight of axle housing, axle shaft, and wheel flange (3) is approximately 98 kg (216 lb). Remove bolts (1).

  3. Remove axle housing, axle shaft, and wheel flange (3) from brake cylinder assembly (2).

  4. Repeat Steps 2 and 3 for the other side.

Information System:

415F2 Industrial Loader Power Train Rear Axle - Install
415F2 Industrial Loader Power Train Rear Axle - Remove
538, 548 and 558 Forest Machine Event Codes
538, 548 and 558 Forest Machine Diagnostic Trouble Codes
415F2 Industrial Loader Power Train Steering Cylinder (Front) - Remove and Install
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Sensor Signal (Analog, Active) - Test
340F Excavator Shipping the Machine
340F Excavator Guards - Operator Protection
GSV520 and GSV525 Orange Peel Grapples Hydraulic Cylinder - Remove and Install
325F Excavator Machine Systems Track - Separate
325F Excavator Machine Systems Track Roller - Remove and Install
415F2 Industrial Loader Power Train Drive and Steering Axle (Front) - Install
415IL Backhoe Loader Power Train Axle Housing, Axle Shaft, and Wheel Flange - Disassemble - Rear Axle
352F Mobile Hydraulic Power Unit (MHPU) Machine Systems Specifications
GSV520 and GSV525 Orange Peel Grapples Bushings (Shell Assembly) - Remove and Install
C9 Engines for Caterpillar Built Machines Piston and Rings
Technical Analysis 1 (TA1) Visual Inspection for Paving Compactors {0372, 1000, 7000, 753S, 7565}
C9 Engines for Caterpillar Built Machines Cylinder Liner
349F XE and 352F XE Excavators Shipping the Machine
CB7, CB8 and CB10 Vibratory Asphalt Compactors Machine Systems Water Spray Lines
538, 548 and 558 Forest Machine Sensor Signal (PWM) - Test
538, 548 and 558 Forest Machine Sensor Signal (Analog, Passive) - Test
538, 548 and 558 Forest Machine Relay - Test
415IL Backhoe Loader Power Train Axle Housing, Axle Shaft, and Wheel Flange - Assemble - Rear Axle