Evaporator Coil - Remove and Install
`
336D 2L and 340D 2L Excavators Machine Systems
[M0065626]
336D 2L and 340D 2L Excavators Machine Systems
Heater Core - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Cab - Remove and Install
OPERATOR STATION
AIR CONDITIONER GP
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems
Actuator Motor (Air Distributor) - Remove and Install
324D, 325D, 326D and 329D Excavators and 329D MHPU Mobile Hydraulic Power Unit Machine Systems
Blower Motor (Air Conditioner, Heater) - Remove and Install
320D Excavator Machine Systems
Refrigerant Receiver-Dryer - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Pressure Switch (Refrigerant Pressure Cutoff) - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Heating and Air Conditioning Unit - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Evaporator Coil - Remove and Install
1.1. Removal Procedure
2.1. Installation Procedure
Start By:
a. Remove the heating and air conditioning unit.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned to prevent dirt from entering the internal mechanism.
- Disconnect harness assemblies (1) and (2).
Show/hide table
Illustration 2 g01187598 - Remove bolts (3).
Show/hide table
Illustration 3 g01187599 - Separate case (4) from case (5).
Show/hide table
Illustration 4 g01187620 - Remove temperature sensor (6).
- Remove evaporator coil (7).
Show/hide table
| |
| Illustration 1 | g01187597 |
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
- Install evaporator coil (7).
- Install temperature sensor (6).
Show/hide table
Illustration 6 g01187599 - Connect case (4) to case (5).
Show/hide table
Illustration 7 g01187598 - Install bolts (3).
Show/hide table
Illustration 8 g01187597 - Connect harness assemblies (1) and (2).
End By:
a. Install the heating and air conditioning unit.
Show/hide table
| |
| Illustration 5 | g01187620 |
Information System:
336D 2L and 340D 2L Excavators Machine Systems
Heater Core - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Heating and Air Conditioning Unit - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Swing Gear and Bearing - Remove and Install
301.7D CR Mini Hydraulic Excavator
Track Adjustment - Inspect
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems
Control Valve and Mounting
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems
Track Roller (Single Flange)
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems
Electronic Control Module
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems
Conveyor System
C2.4 Tier 4 Final Engines for Caterpillar Built Machines
Alternator - Remove and Install
PM620, PM622, PM820 and PM822 and PM825 Cold Planer Machine Systems
Operator Console
Installation Master Guide for the <NOBR>503-4975</NOBR> Auxiliary Control Ar on Certain Hydraulic Excavators {5051}
Installation of the <NOBR>255-2082</NOBR> Pilot Lines Gp on Certain Hydraulic Excavators {5057, 5059}
336D 2L and 340D 2L Excavators Machine Systems
Cab - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Fuel Tank - Remove and Install
Improved Hoses Are Now Used on Certain Backhoe Loaders {5057}
New Rear Axle and Brake Control Groups Are Now Used On Certain 424B Backhoe Loaders {3278, 3282, 4269}
352F Mobile Hydraulic Power Unit (MHPU) Machine System
Main Hydraulic System
336D 2L and 340D 2L Excavators Machine Systems
Hydraulic Lockout Control - Remove and Install
336D 2L and 340D 2L Excavators Machine Systems
Window Wiper Motor - Remove and Install - Lower
GSH420, GSH425, GSH440, GSH520, GSH525, GSH455 and GSH555 Orange Peel Grapples
Head Assembly and Bushing - Remove and Install
349F and 352F Excavators
Joystick Controls - Cat Grade With Assist System
314F and 315F Excavators Machine System Specifications
Control Valve (Auxiliary)
An Improved Main Control Valve is Now Used on 308E2 CR and 308E2 SR Mini Hydraulic Excavators {5051}
314F and 315F Excavators Machine System Specifications
Chassis Lighting