3064 and 3066 Engines for Caterpillar Built Machines Camshaft Bearings - Remove Caterpillar


Camshaft Bearings - Remove
`
1.1. Removal Procedure

Removal Procedure

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     8S-2241     Camshaft Bearing Tool Group     1    
8H-0684 Ratchet Wrench     1    

Start By:

  1. Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
  2. Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.





    Illustration 1g00612707

  1. Remove plug (1) from the cylinder block.



    Illustration 2g00533095



    Illustration 3g00533096

  1. Use Tool (A) in order to remove the camshaft bearings from the cylinder block.

    Note: Refer to the instructions of the 8S-2241 Camshaft Bearing Tool Group for the proper procedure.

Information System:

3064 and 3066 Engines for Caterpillar Built Machines Camshaft - Remove
C15 Petroleum Generator Set Engines Electronic Unit Injector - Adjust
3500B Engines for 5130B and 5230B Excavators Ground Level Shutdown Switch
5230B Excavator Hydraulic System Solenoid Valves (Pilot Manifold)
305 CR Mini Hydraulic Excavator Window (Front) - If Equipped
3500B Engines for 5130B and 5230B Excavators Ether Injection System
5130B Excavator Automatic Lubrication System Grease - Add
3126B Engines Fuel System - Inspect
2001/09/17 Correction to Serial Numbers for "Alternator Debris Guard Available" {1405}
3126B Engine for Caterpillar Built Machines Engine Fan Control Solenoid Circuit - Test
5130B Excavator Pump Drive Oil - Change
C9.3 Engines for Caterpillar Built Machines Electrical System
5130B Excavator Swing Drive Oil - Change
3064 and 3066 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install
3500B Engines for 5130B and 5230B Excavators Injector Solenoids
HDB Series and M1 Series Heavy Duty Brushless Alternators Alternator - Disassemble - M1 Series Alternator (35 Amp)
M312, M315, M318 and M320 Excavators Hydraulic System Relief Valve (Signal Limiter)
M318 Excavator Hydraulic System General Testing and Adjusting Information
5130B Excavator Hydraulic System Oil Level - Check
5230B Excavator Machine Electronic Control System Swing Brake Function
3500B Engines for 5130B and 5230B Excavators Power Shift Solenoid Circuit - Test
5130B Excavator Engine Air Filter Service Indicator - Inspect
3064 and 3066 Engines for Caterpillar Built Machines Coolant Temperature Switch - Remove and Install
3500B Engines Engine Oil Pressure is Low