3064 and 3066 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install Caterpillar


Crankcase Breather - Remove and Install
`
3064 and 3066 Engines for Caterpillar Built Machines [SENR5553]
LUBRICATION SYSTEM
BREATHER GP
3064 and 3066 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install
1.1. Removal Procedure
2.1. Installation

Removal Procedure


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.



NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Refer to Special Publication, NENG2500, "AVSpare Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on AVSpare products.

Dispose of all fluids according to local regulations and mandates.





    Illustration 1g00814599

  1. Loosen hose clamps (2) on hose (1). Remove the hose from the breather assembly (3) .

  1. Remove breather assembly (3) from valve mechanism cover (4) .

Installation


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.





    Illustration 2g00814599

  1. Install new breather assembly (3).

  1. Install hose (1) on the breather assembly (3) and tighten the hose clamp (2) .

Information System:

5130B Excavator Swing Drive Oil - Change
3064 and 3066 Engines for Caterpillar Built Machines Camshaft Bearings - Remove
3064 and 3066 Engines for Caterpillar Built Machines Camshaft - Remove
C15 Petroleum Generator Set Engines Electronic Unit Injector - Adjust
3500B Engines for 5130B and 5230B Excavators Ground Level Shutdown Switch
5230B Excavator Hydraulic System Solenoid Valves (Pilot Manifold)
305 CR Mini Hydraulic Excavator Window (Front) - If Equipped
3500B Engines for 5130B and 5230B Excavators Ether Injection System
5130B Excavator Automatic Lubrication System Grease - Add
3126B Engines Fuel System - Inspect
2001/09/17 Correction to Serial Numbers for "Alternator Debris Guard Available" {1405}
3126B Engine for Caterpillar Built Machines Engine Fan Control Solenoid Circuit - Test
3500B Engines for 5130B and 5230B Excavators Injector Solenoids
HDB Series and M1 Series Heavy Duty Brushless Alternators Alternator - Disassemble - M1 Series Alternator (35 Amp)
M312, M315, M318 and M320 Excavators Hydraulic System Relief Valve (Signal Limiter)
M318 Excavator Hydraulic System General Testing and Adjusting Information
5130B Excavator Hydraulic System Oil Level - Check
5230B Excavator Machine Electronic Control System Swing Brake Function
3500B Engines for 5130B and 5230B Excavators Power Shift Solenoid Circuit - Test
5130B Excavator Engine Air Filter Service Indicator - Inspect
3064 and 3066 Engines for Caterpillar Built Machines Coolant Temperature Switch - Remove and Install
3500B Engines Engine Oil Pressure is Low
3064 and 3066 Engines for Caterpillar Built Machines Engine Oil Pressure Switch - Remove and Install
5230B Excavator Machine Electronic Control System Travel Brake Function