Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7575 | Link Bracket | 3 |
Note: Put identification marks on all hose assemblies and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps keep contaminants out of the system.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
![]() |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
- Disconnect hose assemblies (1). Remove bolts (2) and cover (3).
Show/hide table
Illustration 2 g00820514 - Attach Tooling (A) and a suitable lifting device on blade cylinder (4). The weight of blade cylinder (4) is approximately
64 kg (141 lb) .Show/hide tableIllustration 3 g00820524 - Remove the retaining bolts which secure pin assemblies (5) in each end of the blade cylinder. Count the shims (6) on each side of the blade cylinder and at each end of the blade cylinder before you remove the blade cylinder. The shims must be placed in the same location when the blade cylinder is installed.
- Remove pin assemblies (5) and lift blade cylinder (4) from the machine.
- Repeat Steps 1 through 4 for the other blade cylinder.
![]() | |
Illustration 1 | g00820497 |