C9.3 Engines for Caterpillar Built Machines Cylinder Block Cover - Remove and Install Caterpillar


Cylinder Block Cover - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure

Removal Procedure

Start By:

  1. Remove the engine control module.


    Illustration 1g06120762

  1. Disconnect tube assembly (1). Disconnect hose assemblies (3). Disconnect harness assemblies (4) and (5). Remove nut (2) and position the harness assembly out of the way. Remove three nuts (6) and remove bracket (7).


    Illustration 2g06121208

  2. Remove bolt (8). Remove stud bolt (9) and remove stud bolt (12).

  3. Remove bolts (10) and remove the cylinder block cover (11).

Installation Procedure


NOTICE

Cleanliness is an important factor. Before assembly, clean all parts thoroughly with cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.



NOTICE

Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.


  1. Install cylinder block cover (11) in the reverse order of removal.


      Illustration 3g06121223
      Tightening sequence

    1. Tighten the bolts and the stud bolts in the above sequence.

Information System:

568 Forest Machine Hydraulic System Cylinder Speed - Check
568 Forest Machine Hydraulic System Cylinder Drift - Check - Empty Bucket
349F and 352F Excavators Hydraulic System Pump Control (Output Flow) - Adjust
C4.4 Industrial Engine Engine Valve Lash - Inspect
C4.4 Industrial Engine Engine Oil Cooler - Inspect
C4.4 Industrial Engine Cylinder Head - Inspect
2010/07/27 A New Recoil Spring is Now Used on Certain 320D Excavators {4157, 4158}
374F Excavator Machine System Boom Lines
2010/04/29 The Frame of the Center Lock Pin Grabber Quick Coupler was Redesigned for Certain Excavators {6129}
C13 Engines for Caterpillar Built Machines Turbocharger - Inspect
C9.3 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
568 Forest Machine Hydraulic System Cylinder Drift - Check - Loaded Bucket/Heel
Installation of the 179-8703 Connecting Lines Gp {5057}
2010/05/10 Fuel Injection Nozzles for 3056E Engines {1251, 1290}
303.5D, 304D, 305.5D and 305D Mini Hydraulic Excavators Engine Supplement Turbocharger - Remove and Install
Installation of the 318-1497 Connecting Lines Gp {0679, 5057}
C9.3 Engines for Caterpillar Built Machines Housing (Front) - Install
568 GF and 568 LL Forest Machine Securing the Machine
C4.4 Industrial Engine Air Inlet and Exhaust System - Series Turbochargers
C4.4 Industrial Engine Cooling System
C4.4 Industrial Engine Basic Engine
Bench Test Procedure for Hydraulic Piston Pumps {0784, 5070}
C4.4 Industrial Engine Lubrication System
C4.4 Industrial Engine Introduction