C9.3 Engines for Caterpillar Built Machines Housing (Front) - Install Caterpillar


Housing (Front) - Install
`
C9.3 <BR>Engines for Caterpillar Built Machines [KENR8149]
BASIC ENGINE
HOUSING GP-FRONT
C9.3 Engines for Caterpillar Built Machines Housing (Front) - Install
1.1. Installation Procedure

Installation Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
8T-9011  Component Cleaner 
4C-9500  Quick Cure Primer 
−  Loctite 17430 

\



    Illustration 1g06113959


    Illustration 2g01351898

  1. Clean the joint face on front housing (6) with Tooling (A).

  2. Apply Tooling (B) to the joint face. Allow the primer to dry for at least 3 to 5 minutes.

    Note: Ensure that the groove for the oil supply is not blocked by excess sealant.

  3. Apply Tooling (C) in a bead with a width of 3.0 ± 0.5 mm (0.12 ± 0.02 inch) to the joint face. Refer to Illustration 2. Spread the sealant uniformly. Front housing (6) must be installed within 10 minutes of applying the sealant.

  4. Position front housing (6) on the cylinder block.


    Illustration 3g06113953

  5. Install bolts (3). Install bolts (4) and (5).


    Illustration 4g06113911

  6. Position engine mount (2) and install bolts (1).

End By:

  1. Install the camshaft.

  2. Install the crankshaft front seal.

  3. Install the vibration damper and the pulley.

Information System: