C6.6 Industrial Engine Engine Oil Pump - Remove Caterpillar


Engine Oil Pump - Remove
`
1.1. Removal Procedure

Removal Procedure

Start By:

  1. Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove" for the correct procedure.


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.



NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Dispose of all fluids according to local regulations and mandates.




    Illustration 1g02429861

  1. If suction pipe (1) has a support bracket, remove bolt (4) from bracket (3). Loosen bolt (2) for the retaining clip.

    Note: Note the position and orientation of the components for the support bracket.

  2. Remove bolts (5). Remove suction pipe (1) from oil pump (8).

  3. Remove gasket (6) (not shown).

  4. Remove bolts (7) and remove the assembly of engine oil pump (8) from the cylinder block.


    Illustration 2g02429917

  5. If necessary, remove bolts (13) and oil pump front cover assembly (9). Remove outer rotor (10) from the housing of the engine oil pump.

    Note: Do not remove dowel (11) or dowel (12) from the housing of the engine oil pump unless the dowels are damaged.

Information System:

C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Filter Base - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
C6.6 Industrial Engine Wastegate Solenoid - Remove and Install
C6.6 Industrial Engine Electronic Unit Injector - Install
C6.6 Industrial Engine Electronic Unit Injector - Remove
C6.6 Industrial Engine Fuel Injection Pump Gear - Install
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems Stick Bearings and Seals - Remove and Install
C6.6 Industrial Engine Engine Oil Pump - Install
C6.6 Industrial Engine Water Pump - Remove
C6.6 Industrial Engine Water Pump - Install
C6.6 Industrial Engine Water Temperature Regulator - Remove and Install
C6.6 Industrial Engine Flywheel - Remove
C6.6 Industrial Engine Flywheel - Install
C6.6 Industrial Engine Crankshaft Rear Seal - Remove
C6.6 Industrial Engine Crankshaft Rear Seal - Install
C6.6 Industrial Engine Flywheel Housing - Remove and Install - Standard Housing
349E Excavator Hydraulic System Return Hydraulic System
C9.3 Engines for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
MP15, MP20, MP30 and MP40 Multi-Processors Bushings - Lubricate