C6.6 Industrial Engine Water Pump - Remove Caterpillar


Water Pump - Remove
`
1.1. Removal Procedure

Removal Procedure

Start By:

  1. Remove the fan and the fan pulley. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.



NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.

Dispose of all fluids according to local regulations and mandates.


  1. Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.

  2. Loosen the hose clamps and remove the hose from the water pump inlet.


    Illustration 1g02164768

  3. Remove bolts (4).

  4. Remove water pump (3) from front cover (1).

    Note: If necessary, tap the water pump with a soft faced hammer in order to loosen the water pump.

  5. Remove gasket (2).

Information System:

C6.6 Industrial Engine Engine Oil Pump - Install
C6.6 Industrial Engine Engine Oil Pump - Remove
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Filter Base - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
C6.6 Industrial Engine Wastegate Solenoid - Remove and Install
C6.6 Industrial Engine Electronic Unit Injector - Install
C6.6 Industrial Engine Electronic Unit Injector - Remove
C6.6 Industrial Engine Water Pump - Install
C6.6 Industrial Engine Water Temperature Regulator - Remove and Install
C6.6 Industrial Engine Flywheel - Remove
C6.6 Industrial Engine Flywheel - Install
C6.6 Industrial Engine Crankshaft Rear Seal - Remove
C6.6 Industrial Engine Crankshaft Rear Seal - Install
C6.6 Industrial Engine Flywheel Housing - Remove and Install - Standard Housing
349E Excavator Hydraulic System Return Hydraulic System
C9.3 Engines for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
MP15, MP20, MP30 and MP40 Multi-Processors Bushings - Lubricate
MP15, MP20, MP30 and MP40 Multi-Processors Rotator Gear - Lubricate
MP15, MP20, MP30 and MP40 Multi-Processors Cutting Edges - Inspect/Replace