C6.6 Industrial Engine Flywheel - Remove Caterpillar


Flywheel - Remove
`
1.1. Removal Procedure

Removal Procedure

Table 1
Required Tools 
Tool  Part Number  Part Description  Qty 
Guide Stud
1/2 inch - UNF by 4 inch 

Start By:

  1. Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install" for the correct procedure.


NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened component life.




    Illustration 1g01336668
    Typical example

  1. Remove bolts from Position (X) from flywheel (1).

  2. Install Tooling (A) in Position (X) to flywheel (1).

  3. Install a suitable lifting device onto flywheel (1). Support the weight of the flywheel. The flywheel can weigh 75 kg (165 lb).

  4. If necessary, remove bolts (2) that secure the housing for pilot bearing (3) to flywheel (1). Remove the housing for pilot bearing (3).

  5. Remove remaining bolts (4).

  6. Use the lifting device to remove the flywheel from the engine.


    Illustration 2g01336669
    Typical example

  7. Inspect flywheel (1) and ring gear (5) for wear and damage. Replace any worn components or damaged components.

  8. To remove flywheel ring gear (5), follow Step 8.a through Step 8.b.

    1. Place the flywheel assembly on a suitable support.

    2. Use a hammer and a punch in order to remove ring gear (5) from flywheel (1).

      Note: Identify the orientation of the teeth on the flywheel ring gear.

Information System:

C6.6 Industrial Engine Water Temperature Regulator - Remove and Install
C6.6 Industrial Engine Water Pump - Install
C6.6 Industrial Engine Water Pump - Remove
C6.6 Industrial Engine Engine Oil Pump - Install
C6.6 Industrial Engine Engine Oil Pump - Remove
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Install - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a High Mounted Filter Base
C6.6 Industrial Engine Engine Oil Cooler - Remove - Engine Oil Cooler with a Low Mounted Filter Base
C6.6 Industrial Engine Engine Oil Filter Base - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valves - Remove and Install
C6.6 Industrial Engine Inlet and Exhaust Valve Springs - Remove and Install
C6.6 Industrial Engine Flywheel - Install
C6.6 Industrial Engine Crankshaft Rear Seal - Remove
C6.6 Industrial Engine Crankshaft Rear Seal - Install
C6.6 Industrial Engine Flywheel Housing - Remove and Install - Standard Housing
349E Excavator Hydraulic System Return Hydraulic System
C9.3 Engines for Caterpillar Built Machines Engine Oil Filter Base - Remove and Install
MP15, MP20, MP30 and MP40 Multi-Processors Bushings - Lubricate
MP15, MP20, MP30 and MP40 Multi-Processors Rotator Gear - Lubricate
MP15, MP20, MP30 and MP40 Multi-Processors Cutting Edges - Inspect/Replace
Improved Jacket Water Circuit Breaker for Certain Electric Power Generators and Work Tools{1383, 1417, 1420}
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems Stick - Remove and Install
C9.3 Engines for Caterpillar Built Machines Inlet Manifold - Remove and Install