C6.6 Industrial Engine Crankshaft - Remove Caterpillar

Removal Procedure

Start By:

1. Remove the engine oil pump. Refer to Disassembly and Assembly, "Engine Oil Pump - Remove" for the correct procedure.

2. Remove the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Remove" for the correct procedure.

3. Remove the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Remove" for the correct procedure.

4. If necessary, remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove" for the correct procedure.

5. If necessary, remove the pistons and connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove" for the correct procedure.

1. The engine should be mounted on a suitable stand and placed in the inverted position.

2. If the cylinder head, the pistons and the connecting rods have not been removed already, remove the connecting rod bearings. Refer to Disassembly and Assembly, "Connecting Rod Bearings - Remove" for the correct procedure.

3. Ensure that the main bearing caps are marked for the location and orientation.
   Show/hide table

   Illustration 1	g02204377

4. Remove bolts (3) from tube assembly (2).

5. Remove tube assembly (2) from the cylinder block.

6. Remove gaskets (1) (not shown).
   Show/hide table

   Illustration 2	g02212653

   Show/hide table

   Illustration 3	g02212654

7. Remove bolts (4) and main bearing caps (5) from the cylinder block.

8. Remove lower main bearing shells (6) from main bearing caps (5). Keep the lower main bearing shells with the respective main bearing caps.

   Note: The lower main bearing shells are plain bearings that have no oil holes.

   Show/hide table

   Illustration 4	g02212693

9. For number six main bearing, remove two thrust washers (7) from the cylinder block. In order to remove thrust washers (7), rotate the crankshaft in the correct direction. If necessary, push the crankshaft toward the front of the engine while you rotate the crankshaft, in order to aid removal. If necessary, push the crankshaft toward the rear of the engine while you rotate the crankshaft, in order to aid removal.

   Note: The thrust washers have a locating tab at one end.

   Show/hide table

   Illustration 5	g02212655

10. Attach Tooling (A) and a suitable lifting device to crankshaft (8). Lift crankshaft (8) out of the cylinder block. The weight of the crankshaft is approximately 56 N·m (41 lb ft).

    Note: Do not damage any of the finished surfaces on the crankshaft. When the crankshaft is removed from the engine, the crankshaft must be supported on a suitable stand in order to prevent damage to the crankshaft timing ring.

    Show/hide table

    Illustration 6	g02212656

11. Remove upper main bearing shells (9) from the cylinder block. Keep the upper main bearing shells with the respective main bearing caps.

    Note: The upper main bearing shells have a groove and two oil holes.

12. If necessary, remove the crankshaft timing ring. Refer to Disassembly and Assembly, "Crankshaft Timing Ring - Remove and Install" for the correct procedure.

13. If necessary, remove the crankshaft gear. Refer to Disassembly and Assembly, "Crankshaft Gear - Remove and Install" for the correct procedure.