Camshaft Position Sensor - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Slide locking tab (2) into the unlocked position. Disconnect harness assembly (1) from camshaft position sensor (3).
- Remove bolt (4). Carefully remove camshaft position sensor (3) from the cylinder block.
Note: Do not use a lever to remove the camshaft position sensor.
- Remove O-ring seal (5) from camshaft position sensor (3).
Show/hide table
| |
| Illustration 1 | g02022992 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal (5) to camshaft position sensor (3).
Note: Do not lubricate the O-ring seal.
- Install camshaft position sensor (3) to the cylinder block. Install bolt (4) and tighten the bolt to a torque of
14 N·m (124 lb in) . - Connect harness assembly (1) to camshaft position sensor (3). Slide locking tab (2) into the locked position.
Show/hide table
|
| |
| Illustration 2 | g02022992 |
Information System:
345C MHPU Mobile Hydraulic Power Unit Hydraulic System
Joystick Control - Calibrate
336D MHPU Mobile Hydraulic Power Unit Hydraulic System
Combined Function Hydraulic System - System 18
345C MHPU Mobile Hydraulic Power Unit Hydraulic System
System Pressure - Release
C4.4 Industrial Engine
Alternator
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems
Boom Bearings and Seals - Remove and Install
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems
Boom - Remove and Install
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems
Boom Cylinder - Remove and Install
C9.3 Engines for Caterpillar Built Machines
Rocker Arm and Shaft - Remove
C6.6 Industrial Engine
Atmospheric Pressure Sensor - Remove and Install
C6.6 Industrial Engine
Refrigerant Compressor - Remove and Install
C4.4 Industrial Engine
Camshaft
C6.6 Industrial Engine
Crankshaft Gear - Remove and Install
C6.6 Industrial Engine
Crankshaft Position Sensor - Remove and Install
C6.6 Industrial Engine
Coolant Temperature Sensor - Remove and Install
C6.6 Industrial Engine
Engine Oil Pressure Sensor - Remove and Install
C6.6 Industrial Engine
Soot Antenna - Remove and Install
C6.6 Industrial Engine
Temperature Sensor (DPF) - Remove and Install
C6.6 Industrial Engine
Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C6.6 Industrial Engine
Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - NRS Inlet and Outlet Pressure Sensors
C6.6 Industrial Engine
Boost Pressure Sensor - Remove and Install
C6.6 Industrial Engine
Inlet Manifold Temperature Sensor - Remove and Install
C6.6 Industrial Engine
Glow Plugs - Remove and Install
C6.6 Industrial Engine
Alternator Belt - Remove and Install
C6.6 Industrial Engine
Idler Pulley - Remove and Install - Grooved Idler Pulley