Crankshaft Position Sensor - Remove and Install
`
C6.6 Industrial Engine
[KENR9110]
C6.6 Industrial Engine
Camshaft Position Sensor - Remove and Install
C6.6 Industrial Engine
Coolant Temperature Sensor - Remove and Install
1.1. Removal Procedure
2.1. Installation Procedure
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Slide locking tab (2) into the unlocked position. Disconnect harness assembly (1) from crankshaft position sensor (3).
- Remove bolt (4) from the cylinder block.
- Carefully remove crankshaft position sensor (3) from the cylinder block.
Note: Do not use a lever to remove the crankshaft position sensor from the cylinder block.
- Remove O-ring seal (5) from crankshaft position sensor (3).
Show/hide table
| |
| Illustration 1 | g02024933 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal (5) to crankshaft position sensor (3).
Note: Do not lubricate the O-ring seal.
- Install crankshaft position sensor (3) to the cylinder block. Install bolt (4) and tighten the bolt to a torque of
14 N·m (124 lb in) . - Connect harness assembly (1) to crankshaft position sensor (3). Slide locking tab (2) into the locked position.
Show/hide table
|
| |
| Illustration 2 | g02024933 |
Information System:
C6.6 Industrial Engine
Camshaft Position Sensor - Remove and Install
345C MHPU Mobile Hydraulic Power Unit Hydraulic System
Joystick Control - Calibrate
336D MHPU Mobile Hydraulic Power Unit Hydraulic System
Combined Function Hydraulic System - System 18
345C MHPU Mobile Hydraulic Power Unit Hydraulic System
System Pressure - Release
C4.4 Industrial Engine
Alternator
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems
Boom Bearings and Seals - Remove and Install
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems
Boom - Remove and Install
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems
Boom Cylinder - Remove and Install
C9.3 Engines for Caterpillar Built Machines
Rocker Arm and Shaft - Remove
C6.6 Industrial Engine
Atmospheric Pressure Sensor - Remove and Install
C6.6 Industrial Engine
Refrigerant Compressor - Remove and Install
C4.4 Industrial Engine
Camshaft
C6.6 Industrial Engine
Coolant Temperature Sensor - Remove and Install
C6.6 Industrial Engine
Engine Oil Pressure Sensor - Remove and Install
C6.6 Industrial Engine
Soot Antenna - Remove and Install
C6.6 Industrial Engine
Temperature Sensor (DPF) - Remove and Install
C6.6 Industrial Engine
Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
C6.6 Industrial Engine
Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - NRS Inlet and Outlet Pressure Sensors
C6.6 Industrial Engine
Boost Pressure Sensor - Remove and Install
C6.6 Industrial Engine
Inlet Manifold Temperature Sensor - Remove and Install
C6.6 Industrial Engine
Glow Plugs - Remove and Install
C6.6 Industrial Engine
Alternator Belt - Remove and Install
C6.6 Industrial Engine
Idler Pulley - Remove and Install - Grooved Idler Pulley
C6.6 Industrial Engine
Idler Pulley - Remove and Install - Flat Idler Pulley