Atmospheric Pressure Sensor - Remove and Install
`
C7.1 Industrial Engine
[KENR9105]
C7.1 Industrial Engine
ARD Spark Plug - Remove and Install
C7.1 Industrial Engine
Belt Tensioner - Remove and Install
1.1. Removal Procedure
2.1. Installation Procedure
- Removal of the Electronic Control Module (ECM) may be necessary in order to remove the atmospheric pressure sensor. If necessary, remove the electronic control module. Refer to Disassembly and Assembly, "Electronic Control Module - Remove and Install" for the correct procedure.
- Slide locking tab (2) into the unlocked position. Disconnect harness assembly (1).
- Remove atmospheric pressure sensor (3) from the bracket for the ECM.
Show/hide table
| |
| Illustration 1 | g02315313 |
- Install atmospheric pressure sensor (3) to the bracket for the ECM. Tighten atmospheric pressure sensor (3) to a torque of
10 N·m (89 lb in) .Note: The atmospheric pressure sensor should not be installed with an O-ring seal.
- Connect harness assembly (1) to atmospheric pressure sensor (3). Slide locking tab (2) into the locked position.
- If removal of the ECM was necessary, install the ECM. Refer to Disassembly and Assembly, "Electronic Control Module - Remove and Install" for the correct procedure.
Show/hide table
|
| |
| Illustration 2 | g02315313 |
Information System:
C7.1 Industrial Engine
ARD Spark Plug - Remove and Install
C7.1 Industrial Engine
Alternator Belt - Remove and Install
C7.1 Industrial Engine
Alternator - Remove
C7.1 Industrial Engine
Alternator - Install
C7.1 Industrial Engine
Air Control Valve - Remove and Install - Clean Emissions Module
Reuse and Salvage for Flywheel Assemblies {0679, 1156}
325 VM and VH Variable Gauge Undercarriage
Sprocket - Remove and Install
325 VM and VH Variable Gauge Undercarriage
Track Roller - Remove and Install
349F and 352F Excavators Machine Systems
Pilot Valve (Joystick) - Assemble
349F and 352F Excavators Machine Systems
Pilot Valve (Joystick) - Disassemble
336E Excavator and 336E MHPU Mobile Hydraulic Power Unit Machine Systems
Fuel Tank - Remove and Install
Reuse Guideline for the Flexible Exhaust Pipe Group on Tier 4 Engines {1061}
C7.1 Industrial Engine
Belt Tensioner - Remove and Install
C7.1 Industrial Engine
Boost Pressure Sensor - Remove and Install
C7.1 Industrial Engine
Camshaft - Remove and Install
C7.1 Industrial Engine
Camshaft Bearings - Remove and Install
C7.1 Industrial Engine
Camshaft Gear - Remove and Install
C7.1 Industrial Engine
Camshaft Position Sensor - Remove and Install
C7.1 Industrial Engine
Catalyst - Remove and Install - Diesel Oxidation Catalyst (DOC)
C7.1 Industrial Engine
Connecting Rod Bearings - Install - Connecting rods in position
C7.1 Industrial Engine
Connecting Rod Bearings - Remove - Connecting rods in position
C7.1 Industrial Engine
Coolant Temperature Sensor - Remove and Install
C7.1 Industrial Engine
Crankcase Breather - Install
C7.1 Industrial Engine
Crankcase Breather - Remove