Camshaft Position Sensor - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Slide locking tab (2) into the unlocked position. Disconnect harness assembly (1) from camshaft position sensor (3).
- Remove bolt (4). Carefully remove camshaft position sensor (3) from the cylinder block.
Note: Do not use a lever to remove the camshaft position sensor.
- Remove O-ring seal (5) from camshaft position sensor (3).
Show/hide table
| |
| Illustration 1 | g02022992 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal (5) to camshaft position sensor (3).
Note: Do not lubricate the O-ring seal.
- Install camshaft position sensor (3) to the cylinder block. Install bolt (4) and tighten the bolt to a torque of
14 N·m (124 lb in) . - Connect harness assembly (1) to camshaft position sensor (3). Slide locking tab (2) into the locked position.
Show/hide table
|
| |
| Illustration 2 | g02022992 |
Information System:
C7.1 Industrial Engine
Camshaft Gear - Remove and Install
C7.1 Industrial Engine
Camshaft Bearings - Remove and Install
C7.1 Industrial Engine
Camshaft - Remove and Install
C7.1 Industrial Engine
Boost Pressure Sensor - Remove and Install
C7.1 Industrial Engine
Belt Tensioner - Remove and Install
C7.1 Industrial Engine
Atmospheric Pressure Sensor - Remove and Install
C7.1 Industrial Engine
ARD Spark Plug - Remove and Install
C7.1 Industrial Engine
Alternator Belt - Remove and Install
C7.1 Industrial Engine
Alternator - Remove
C7.1 Industrial Engine
Alternator - Install
C7.1 Industrial Engine
Air Control Valve - Remove and Install - Clean Emissions Module
Reuse and Salvage for Flywheel Assemblies {0679, 1156}
C7.1 Industrial Engine
Catalyst - Remove and Install - Diesel Oxidation Catalyst (DOC)
C7.1 Industrial Engine
Connecting Rod Bearings - Install - Connecting rods in position
C7.1 Industrial Engine
Connecting Rod Bearings - Remove - Connecting rods in position
C7.1 Industrial Engine
Coolant Temperature Sensor - Remove and Install
C7.1 Industrial Engine
Crankcase Breather - Install
C7.1 Industrial Engine
Crankcase Breather - Remove
C7.1 Industrial Engine
Crankshaft - Install
C7.1 Industrial Engine
Crankshaft - Remove
C7.1 Industrial Engine
Crankshaft Front Seal - Remove and Install
C7.1 Industrial Engine
Crankshaft Gear - Remove and Install
C7.1 Industrial Engine
Crankshaft Main Bearings - Remove and Install - Crankshaft in position
C7.1 Industrial Engine
Crankshaft Position Sensor - Remove and Install