C7.1 Industrial Engine Crankcase Breather

Crankcase Breather - Remove

C7.1 Industrial Engine [KENR9105]

1.1. Removal Procedure

Removal Procedure

Show/hide table

NOTICE

Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table

NOTICE

When disconnecting and connecting the plastic tube assemblies for the crankcase breather system, the plastic tube assemblies should not be twisted. Twisting of the plastic tube assemblies will result in the seals being damaged. Damaged to seals will result in leakage.

Show/hide table

Show/hide table

Cut cable strap (2) from plastic tube assembly (3).
Remove plastic tube assembly (3) from breather canister (1) and the valve mechanism cover.
If necessary, cut cable straps in order to remove plastic tube assembly (4) from breather canister (1).
Remove plastic tube assembly (5) from breather canister (1) and adapter (6) in the cylinder block.
Remove bolts (7) and remove breather canister (1) from the cylinder head.
Show/hide table

Illustration 3 g02163115
Remove bolt (8) and remove valve (6) from the cylinder block.
Remove O-ring seal (9) from valve (6).
Show/hide table

Illustration 4 g02163116
If necessary, follow Step 8.a through Step 8.e in order to disassemble the breather canister.
1. Remove bottom cap (14) from breather canister (1).
2. Remove seal (13) from bottom cap (14).
3. Remove filter element (12) from breather canister (1). Refer to Operation and Maintenance Manual, "Engine Crankcase Breather Element - Replace" for the correct procedure.
4. Remove top cap (10) from breather canister (1).
5. Remove seal (11) from top cap (10).