Crankshaft Position Sensor - Remove and Install
`
1.1. Removal Procedure
2.1. Installation Procedure
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Slide locking tab (2) into the unlocked position. Disconnect harness assembly (1) from crankshaft position sensor (3).
- Remove bolt (4) from the cylinder block.
- Carefully remove crankshaft position sensor (3) from the cylinder block.
Note: Do not use a lever to remove the crankshaft position sensor from the cylinder block.
- Remove O-ring seal (5) from crankshaft position sensor (3).
Show/hide table
| |
| Illustration 1 | g02315333 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal (5) to crankshaft position sensor (3).
Note: Do not lubricate the O-ring seal.
- Install crankshaft position sensor (3) to the cylinder block. Install bolt (4) and tighten the bolt to a torque of
14 N·m (124 lb in) . - Connect harness assembly (1) to crankshaft position sensor (3). Slide locking tab (2) into the locked position.
Show/hide table
|
| |
| Illustration 2 | g02315333 |
Information System:
C7.1 Industrial Engine
Crankshaft Main Bearings - Remove and Install - Crankshaft in position
C7.1 Industrial Engine
Crankshaft Gear - Remove and Install
C7.1 Industrial Engine
Crankshaft Front Seal - Remove and Install
C7.1 Industrial Engine
Crankshaft - Remove
C7.1 Industrial Engine
Crankshaft - Install
C7.1 Industrial Engine
Crankcase Breather - Remove
C7.1 Industrial Engine
Crankcase Breather - Install
C7.1 Industrial Engine
Coolant Temperature Sensor - Remove and Install
C7.1 Industrial Engine
Connecting Rod Bearings - Remove - Connecting rods in position
C7.1 Industrial Engine
Connecting Rod Bearings - Install - Connecting rods in position
C7.1 Industrial Engine
Catalyst - Remove and Install - Diesel Oxidation Catalyst (DOC)
C7.1 Industrial Engine
Camshaft Position Sensor - Remove and Install
C7.1 Industrial Engine
Crankshaft Rear Seal - Install
C7.1 Industrial Engine
Crankshaft Rear Seal - Remove
C7.1 Industrial Engine
Crankshaft Timing Ring - Remove and Install
C7.1 Industrial Engine
Cylinder Head - Install
C7.1 Industrial Engine
Cylinder Head - Remove
C7.1 Industrial Engine
Diesel Particulate Filter - Assemble
C7.1 Industrial Engine
Diesel Particulate Filter - Disassemble
C7.1 Industrial Engine
Diesel Particulate Filter - Install
C7.1 Industrial Engine
Diesel Particulate Filter - Remove
C7.1 Industrial Engine
ECM Mounting Bracket - Remove and Install
C7.1 Industrial Engine
Electric Starting Motor - Remove and Install
C7.1 Industrial Engine
Electronic Control Module - Remove and Install - Electronic Control Module With Quick Coupler Connections