C7.1 Industrial Engine Engine Oil Pan Plate - Remove and Install

Engine Oil Pan Plate - Remove and Install - Aluminum Oil Pan

C7.1 Industrial Engine [KENR9105]

1.1. Removal Procedure

2.1. Installation Procedure

Removal Procedure

Show/hide table

Start By:

Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove" for the correct procedure.
Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install" for the correct procedure.

Show/hide table

NOTICE

Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates.

Show/hide table

Support isolating frame (3). Use Tooling (A) to remove Torx screws (2) and Torx screws (4).
Remove isolating frame (3) from the cylinder block.
Remove gasket (1).

Show/hide table

Show/hide table

NOTICE

Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table

NOTICE

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates.

Show/hide table

Ensure that the gasket surface of the cylinder block is clean and free from damage.
Install Tooling (B) to Positions (X) in the cylinder block.
Ensure that the isolating frame is clean and free from damage. If necessary, replace the isolating frame.
Show/hide table

Illustration 3 g02011517
Position a new gasket (1) onto isolating frame (3).
Align isolating frame (3) with Tooling (B). Install the isolating frame to the cylinder block.
Use Tooling (A) to install Torx screws (2) and Torx screws (4) to the isolating frame finger tight.
Tighten Torx screws (2) and Torx screws (4) to a torque of 22 N·m (195 lb in).

End By:

Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove" for the correct procedure.
Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install" for the correct procedure.