Engine Oil Pump - Remove
`
C7.1 Industrial Engine
[KENR9105]
C7.1 Industrial Engine
Engine Oil Pump - Install
C7.1 Industrial Engine
Exhaust Cooler (NRS) - Remove and Install
1.1. Removal Procedure
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove" for the correct procedure.
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- If suction pipe (1) has a support bracket, remove bolt (4) from bracket (3). Loosen bolt (2) for the retaining clip.
Note: Note the position and orientation of the components for the support bracket.
- Remove bolts (5). Remove suction pipe (1) from oil pump (8).
- Remove gasket (6) (not shown).
- Remove bolts (7) and remove the assembly of engine oil pump (8) from the cylinder block.
Show/hide table
Illustration 2 g02367718 - If necessary, remove bolts (13) and front cover assembly (9). Remove outer rotor (10) from the housing of the engine oil pump.
Note: Do not remove dowel (11) or dowel (12) from the housing of the engine oil pump unless the dowels are damaged.
Show/hide table
| |
| Illustration 1 | g02367717 |
Information System:
C7.1 Industrial Engine
Engine Oil Pump - Install
C7.1 Industrial Engine
Engine Oil Pressure Sensor - Remove and Install
C7.1 Industrial Engine
Engine Oil Pan Plate - Remove and Install - Aluminum Oil Pan
C7.1 Industrial Engine
Engine Oil Pan - Remove - Aluminum Oil Pan
C7.1 Industrial Engine
Engine Oil Pan - Install - Aluminum Oil Pan
C7.1 Industrial Engine
Engine Oil Filter Base - Remove and Install - Engine Oil Filter Base with Adapter
C7.1 Industrial Engine
Engine Oil Filter Base - Remove and Install
C7.1 Industrial Engine
Engine Oil Cooler - Remove - Engine Oil Cooler with a Low Mounted Filter Base
C7.1 Industrial Engine
Engine Oil Cooler - Remove - Engine Oil Cooler with a High Mounted Filter Base
C7.1 Industrial Engine
Engine Oil Cooler - Install - Engine Oil Cooler with a Low Mounted Filter Base
C7.1 Industrial Engine
Engine Oil Cooler - Install - Engine Oil Cooler with a High Mounted Filter Base
C7.1 Industrial Engine
Electronic Unit Injector - Remove
C7.1 Industrial Engine
Exhaust Cooler (NRS) - Remove and Install
C7.1 Industrial Engine
Exhaust Manifold - Remove and Install
C7.1 Industrial Engine
Fan - Remove and Install
C7.1 Industrial Engine
Fan Drive - Remove and Install
C7.1 Industrial Engine
Flame Detection Temperature Sensor - Remove and Install - Flame Detection Temperature Sensor for the ARD
C7.1 Industrial Engine
Flywheel - Install - Equipped with Rear Power Take-Off
C7.1 Industrial Engine
Flywheel - Install
C7.1 Industrial Engine
Flywheel - Remove - Equipped with Rear Power Take-Off
C7.1 Industrial Engine
Flywheel - Remove
C7.1 Industrial Engine
Flywheel Housing - Remove and Install - Standard Housing
C7.1 Industrial Engine
Flywheel Housing - Remove and Install - Flywheel Housing that is Equipped with Rear Power Take-Off
C7.1 Industrial Engine
Front Cover - Remove and Install - Heavy Duty Front Cover