C7.1 Industrial Engine Flywheel - Remove Caterpillar

Removal Procedure

Start By:

1. Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install" for the correct procedure.

Show/hide table

Illustration 1	g01336668
Typical example

1. Remove bolts from Position (X) from flywheel (1).

2. Install Tooling (A) in Position (X) to flywheel (1).

3. Install a suitable lifting device onto flywheel (1). Support the weight of the flywheel. The flywheel can weigh 71 kg (156 lb).

4. If necessary, remove bolts (2) that secure the housing for pilot bearing (3) to flywheel (1). Remove the housing for pilot bearing (3).

5. Remove remaining bolts (4).

6. Use the lifting device to remove the flywheel from the engine.
   Show/hide table

   Illustration 2	g01336669
   Typical example

7. Inspect flywheel (1) and ring gear (5) for wear and damage. Replace any worn components or damaged components.

8. To remove flywheel ring gear (5), follow Step 8.a through Step 8.b.

   1. Place the flywheel assembly on a suitable support.

   2. Use a hammer and a punch in order to remove ring gear (5) from flywheel (1).

      Note: Identify the orientation of the teeth on the flywheel ring gear.