Fuel Injection Pump Gear - Remove
`
C7.1 Industrial Engine
[KENR9105]
C7.1 Industrial Engine
Fuel Injection Pump Gear - Install
C7.1 Industrial Engine
Fuel Manifold (Rail) - Remove and Install
1.1. Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | - | Puller (Two Legged) | 1 |
| B | - | E10 Torx Socket 1/4" Square Drive |
1 |
Start By:
- Remove the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Remove" for the correct procedure.
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- Use a suitable tool in order to prevent fuel injection pump gear (3) from rotating.
Note: Do not use timing pin for the fuel injection in order to prevent the fuel injection pump gear from rotating.
- Remove nut (1) and washer (2).
- Use Tooling (A) in order to remove gear (3) from the shaft of fuel injection pump (7).
- Remove key (6) from the shaft of fuel injection pump (7).
- Use Tooling (B) in order to remove Torx screws (8) and washers.
- Remove adapter plate (4) from fuel injection pump (7).
- Remove O-ring seal (5).
Show/hide table
| |
| Illustration 1 | g01970674 |
Information System:
C7.1 Industrial Engine
Fuel Injection Pump Gear - Install
C7.1 Industrial Engine
Fuel Injection Pump - Remove
C7.1 Industrial Engine
Fuel Injection Pump - Install
C7.1 Industrial Engine
Fuel Injection Lines - Remove
C7.1 Industrial Engine
Fuel Injection Lines - Install
C7.1 Industrial Engine
Fuel Filter Base - Remove and Install - Twin Secondary Fuel Filter
C7.1 Industrial Engine
Fuel Filter Base - Remove and Install - Single Secondary Fuel Filter
C7.1 Industrial Engine
Front Cover - Remove and Install
C7.1 Industrial Engine
Front Cover - Remove and Install - Heavy Duty Front Cover
C7.1 Industrial Engine
Flywheel Housing - Remove and Install - Flywheel Housing that is Equipped with Rear Power Take-Off
C7.1 Industrial Engine
Flywheel Housing - Remove and Install - Standard Housing
C7.1 Industrial Engine
Flywheel - Remove
C7.1 Industrial Engine
Fuel Manifold (Rail) - Remove and Install
C7.1 Industrial Engine
Fuel Pump (ARD) - Remove and Install
C7.1 Industrial Engine
Gear Group (Front) - Remove and Install - Heavy Duty Gear Group (Front)
C7.1 Industrial Engine
Gear Group (Front) - Remove and Install
C7.1 Industrial Engine
Glow Plugs - Remove and Install
C7.1 Industrial Engine
Housing (Front) - Install - Heavy Duty Housing (Front)
C7.1 Industrial Engine
Housing (Front) - Install
C7.1 Industrial Engine
Housing (Front) - Remove - Heavy Duty Housing (Front)
C7.1 Industrial Engine
Housing (Front) - Remove
C7.1 Industrial Engine
Idler Gear - Install
C7.1 Industrial Engine
Idler Gear - Remove
C7.1 Industrial Engine
Idler Pulley - Remove and Install - Flat Idler Pulley